Characteristics of dynamic ice-making via Al2O3-H2O nanofluid's vacuum flash

ZHANG Xuelai; WANG Zhangfei; LI Yue; JIA Xiaoya

doi:10.11949/j.issn.0438-1157.20170612

您当前的位置：

首页 >

文章列表页 >

Characteristics of dynamic ice-making via Al₂O₃-H₂O nanofluid's vacuum flash

更新时间：2025-12-10

- Characteristics of dynamic ice-making via Al₂O₃-H₂O nanofluid's vacuum flash
- CIESC Journal Issue 4, Pages: 1332-1340(2018)
- 作者机构：
  
  上海海事大学蓄冷技术研究所,上海,201306
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20170612
  CLC： K02
- Online First：05 April 2018，
  
  Published：05 April 2018
- 稿件说明：
移动端阅览
ZHANG Xuelai, WANG Zhangfei, LI Yue, et al. Characteristics of dynamic ice-making via Al₂O₃-H₂O nanofluid's vacuum flash[J]. CIESC Journal, 2018, (4): 1332-1340. DOI: 10.11949/j.issn.0438-1157.20170612.
DOI：

ZHANG Xuelai, WANG Zhangfei, LI Yue, et al. Characteristics of dynamic ice-making via Al₂O₃-H₂O nanofluid's vacuum flash[J]. CIESC Journal, 2018, (4): 1332-1340. DOI: 10.11949/j.issn.0438-1157.20170612. DOI：

摘要

配制溶质为Al2O3纳米粒子、黄原胶为分散剂，经超声波振荡后分散均匀稳定的Al2O3-H2O纳米流体。利用真空动态喷射制冰实验装置，设定初始压力300 Pa，研究在有无固体吸附作用、不同纳米流体浓度、不同纳米颗粒粒径和不同供液流量下的真空闪蒸制冰特性。结果表明，吸附作用对真空制冰系统稳压效果显著且有助于捕捉实验中的水蒸气；当冷却介质温度低于吸附剂初始温度时，吸附剂有更好的吸附能力但冷却温度不宜过低；纳米流体浓度越大、纳米粒子粒径越小，更利于制取高含冰率的冰浆；对于同一浓度的纳米流体，合理控制供液流量可以获得不同含冰率的冰浆；在2%（质量）NaCl下，各粒径的纳米流体浓度不宜超过0.05%（质量）。

Abstract

Al2O3 nano particles were added into the water with xanthan and ultrasonic wave to prepare the well-distributed Al2O3-H2O nanofluid. Based on the theory of flash evaporation

an experimental apparatus of dynamic ice-making under vacuum was designed. In the same flash pressure (300 Pa)

it is investigated the vacuum flash experimental characteristics in different conditions

like solid adsorption

nanofluid concentration

particle size and diaphragm metering pump flow. The results shown that the adsorption action had obvious effect on keeping the stability of the pressure and it was useful to capture the water vapor in the system. When the temperature of the cooling medium is lower than the initial temperature of the adsorbent

the adsorbent had better adsorption capacity

but the cooling temperature should not be too low. The larger the concentraction of the nanofluid is

the smaller the particle size is

the better for getting the high ice packing factor of ice slurry. For the same concentration of nanofluid

ice packing factor of ice slurry can be gotten by reasonable to control the diaphragm metering pump flow. In 2%(mass) NaCl

the nanofluid concentration in different particle size should not exceed 0.05%(mass).

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Experimental analysis of ice-making characteristics with adsorption in vacuum environment

Preparation and thermophysical property optimization of a new composite phase change material for cold storage

Preparation and heat transfer characteristics of GO/paraffin composite phase change emulsions

Study on flash evaporation characteristics as well as thermodynamic variation performance in liquid hydrogen tank during on-orbit venting

Study on enhanced pool boiling heat transfer based on self-driven jet device

Related Author

ZHANG Xuelai

ZHAO Qunzhi

MENG Xianglai

LI Chunlei

XU Bin

Puyue JIA

Weidong WU

Yicong WANG

Related Institution

Institute of Cool Thermal Storage Technology, Shanghai Maritime University

Institute of Refrigeration and Cryogenics Engineering, University of Shanghai for Science and Technology

Faculty of Maritime and Transportation，Ningbo University

Department of Refrigeration and Cryogenic Engineering, Xi’an Jiaotong University

Shanghai Aerospace System Engineering

⁰