Numerical simulation of wall effect in randomly packed bed with low tube to particle diameter ratio

HU Yingxue; ZHOU Lang; YANG Jian; WANG Qiuwang

doi:10.11949/j.issn.0438-1157.20170513

您当前的位置：

首页 >

文章列表页 >

Numerical simulation of wall effect in randomly packed bed with low tube to particle diameter ratio

更新时间：2025-12-10

- Numerical simulation of wall effect in randomly packed bed with low tube to particle diameter ratio
- CIESC Journal Issue S1, Pages: 54-59(2017)
- 作者机构：
  
  西安交通大学热流科学与工程教育部重点实验室,陕西,西安,710049
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20170513
  CLC： K124
- Online First：31 August 2017，
  
  Published：31 August 2017
- 稿件说明：
移动端阅览
HU Yingxue, ZHOU Lang, YANG Jian, et al. Numerical simulation of wall effect in randomly packed bed with low tube to particle diameter ratio[J]. CIESC Journal, 2017, (S1): 54-59.
DOI：

HU Yingxue, ZHOU Lang, YANG Jian, et al. Numerical simulation of wall effect in randomly packed bed with low tube to particle diameter ratio[J]. CIESC Journal, 2017, (S1): 54-59. DOI： 10.11949/j.issn.0438-1157.20170513.

摘要

采用DEM-CFD方法对小管径-粒径比颗粒无序堆积通道内壁面效应进行了数值研究。针对D/dp=5.0圆球无序堆积通道构建了光滑壁面和波节壁面两种通道壁面结构，分析了不同壁面结构堆积通道内孔隙率分布、流动和温度场分布及其流动换热性能。结果表明：小管径-粒径比光滑壁面颗粒无序堆积通道内壁面效应显著，壁面附近平均流速明显高于堆积中心区域，而平均温度要低于堆积中心区域，壁面附近0.5dp区域内通过的流体质量流量比例为46%；波节壁面结构抑制了通道壁面附近漏流，可小幅提高堆积通道的换热能力，但堆积通道内的流动阻力也随之增大，其综合换热性能较光滑壁面堆积通道有所下降。

Abstract

The wall effect in randomly packed bed with low tube to particle ratio is numerically investigated by coupling discrete element method (DEM) and computational fluid dynamics (CFD). The porosity

characteristics of fluid flow and heat transfer in randomly packed beds are carefully studied

including smooth tube wall model and corrugated tube wall model. Simulation results show that

the wall effect in smooth wall packing with low tube to particle diameter ratio is remarkable. The average velocity of the near tube wall region is higher than inner region

while the average temperature of this region is lower. Besides

the mass flow rate in the range of 0.5dp near the tube wall is about 46% of the total flow. With corrugated structure

the leakage near the tube wall is suppressed and the mass flow rate decreases to 36%. The heat transfer characteristics and drag coefficient have a slight increase

while the overall heat transfer coefficient is lower than smooth tube wall model.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Numerical study on flow and heat transfer characteristics of airfoil printed circuit heat exchangers

Study on flow and heat transfer mechanism of supercritical CO2 in inclined upward tube under cooling conditions

Optimization on parameter of plate-fin-and-tube air cooler in mines based on response surface method

Performance analysis of printed circuit heat exchanger for supercritical carbon dioxide

Study on influence of mechanical stirring on heat transfer characteristics during jet heating of crude oil storage tank

Related Author

REN Guanyu

ZHANG Yifei

LI Xinze

DU Wenjing

DONG Xinyu

BIAN Longfei

YANG Yiyi

ZHANG Yuxuan

Related Institution

School of Energy and Power Engineering, Shandong University

Hebei Key Laboratory of Low Carbon and High Efficiency Power Generation Technology, North China Electric Power University

State Key Laboratory of Intelligent Construction and Healthy Operation and Maintenance of Deep Underground Engineering, China University of Mining and Technology

School of Mechanics and Civil Engineering, China University of Mining and Technology

China Coal Construction Company

⁰