Model of estimating viscosity based on slag structure in entrained flow gasifier

WANG Qian; LI Qiang; ZHANG Jiansheng

doi:10.11949/j.issn.0438-1157.20170443

您当前的位置：

首页 >

文章列表页 >

Model of estimating viscosity based on slag structure in entrained flow gasifier

更新时间：2025-12-10

- Model of estimating viscosity based on slag structure in entrained flow gasifier
- CIESC Journal Issue 10, Pages: 3877-3883(2017)
- 作者机构：
  
  清华大学热能工程系, 热科学与动力工程教育部重点实验室,北京,100084
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20170443
  CLC： Q546.4
- Online First：05 October 2017，
  
  Published：05 October 2017
- 稿件说明：
移动端阅览
WANG Qian, LI Qiang, ZHANG Jiansheng. Model of estimating viscosity based on slag structure in entrained flow gasifier[J]. CIESC Journal, 2017, (10): 3877-3883.
DOI：

WANG Qian, LI Qiang, ZHANG Jiansheng. Model of estimating viscosity based on slag structure in entrained flow gasifier[J]. CIESC Journal, 2017, (10): 3877-3883. DOI： 10.11949/j.issn.0438-1157.20170443.

摘要

在煤气化工艺中，煤灰高温黏度特性是影响熔渣流动特性重要参数之一。以NBO/T、P/M为结构参数，建立熔渣高温黏度预测模型，对结构参数、熔渣黏度的关系进行了研究，并通过文献的实验数据验证了模型的准确性。研究发现随着NBO/T的增大，熔体聚合程度降低，熔体流动时内摩擦力减小，黏度降低；随着P/M增大，熔体结构强度减弱，熔体流动所需要克服的阻力增加，熔渣黏度逐渐升高。引入结构参数后的熔渣黏度预测模型对一定范围内的熔渣黏度具有良好的预测效果，在NBO/T < 0.5时，黏度预测值和实验值误差在10%以内，采用两种结构参数均可；在NBO/T > 0.5时，黏度预测值和实验值误差在25%以内，采用结构参数P/M更合适。

Abstract

The viscosity of molten slags is one of the most significant parameters to predict the flow properties of ash in coal gasification process.To estimate the viscosity of molten slags

a model based on the structure of slags was established.NBO/T (number of non-bridging oxygen/tetragonally-bonded oxygen) and P/M (polymer/modifier)

as the structural parameters of slags

provide description of the polymerization and bond strengths of molten slags

respectively.The model presented the dependency on both temperature and structural parameters with the viscosity in the SiO2-Al2O3-CaO-MgO-Fe2O3-K2O-Na2O-TiO2 slag systems.The accuracy of the model was verified by the experimental data of literatures.The results indicate that the viscosity decreases with the increase of NBO/T due to the reduction of polymerization in the molten slags

whereas the viscosity rises with the increase of P/M because of the strength weaken of molten slags.A good agreement is obtained from the calculated and measured values of the viscosity within a certain range.The deviation between the prediction and experiment results is within 10% when NBO/T < 0.5 and 25% when NBO/T > 0.5.

关键词

Keywords

references

Views

202

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Development of coal ash/slag viscosity-temperature model based on crystal growth and morphologies

Effect of burner bias angle on distribution characteristics of gasifier slag layer

Mechanism of alkali metal/(FeO+CaO+MgO) influence on the structure and viscosity of silicate ash slag

Viscosity estimation of fluid mixtures based on Eyring's absolute rate theory

Research on vibration attrition of steel balls in liquid

Related Author

Zhongjie SHEN

Xiaolei GUO

Qinfeng LIANG

Haifeng LIU

ZHOU Bimao

XU Shisen

WANG Xiaoxiao

LIU Gang

Related Institution

Shanghai Engineering Research Center of Coal Gasification, East China University of Science and Technology

MOE Key Laboratory of Thermo-fluid Science and Engineering, Xi’an Jiaotong University

Huaneng Clean Energy Research Institute, State Key Laboratory of Coal Based Clean Energy

School of Energy and Environmental Engineering, University of Science and Technology Beijing

Beijing Key Laboratory of Process Fluid Filtration and Separation, College of Mechanical and Transportation Engineering, China University of Petroleum

⁰