Influence of nozzle spacing on mixing behavior of two parallel jets from rectangular nozzles

LIU Pengyuan; ZHANG Hai; WU Yuxin; ZHANG Man; LÜ Junfu

doi:10.11949/j.issn.0438-1157.20170380

您当前的位置：

首页 >

文章列表页 >

Influence of nozzle spacing on mixing behavior of two parallel jets from rectangular nozzles

更新时间：2025-12-10

- Influence of nozzle spacing on mixing behavior of two parallel jets from rectangular nozzles
- CIESC Journal Issue 10, Pages: 3708-3716(2017)
- 作者机构：
  
  清华大学热能工程系, 热科学与动力工程教育部重点实验室,北京,100084
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20170380
  CLC： K221TK229.6
- Online First：05 October 2017，
  
  Published：05 October 2017
- 稿件说明：
移动端阅览
LIU Pengyuan, ZHANG Hai, WU Yuxin, et al. Influence of nozzle spacing on mixing behavior of two parallel jets from rectangular nozzles[J]. CIESC Journal, 2017, (10): 3708-3716.
DOI：

LIU Pengyuan, ZHANG Hai, WU Yuxin, et al. Influence of nozzle spacing on mixing behavior of two parallel jets from rectangular nozzles[J]. CIESC Journal, 2017, (10): 3708-3716. DOI： 10.11949/j.issn.0438-1157.20170380.

摘要

用激光粒子测试仪（PIV）测量了双矩形喷口平行射流的流场特性，研究了不同喷口速度、不同喷口间距下双射流的混合特性。结果表明，喷口速度增大，双射流对称线上速度绝对值增大，但速度最大值出现的位置基本不变。喷口间距增大后，双射流的混合推迟，合并点后移，传递到对称线上的动量减弱，在合并点上的最大速度值减小。间距比与合并点的关系呈线性；但与大间距比相比，小间距比对合并点的影响更为敏感，关联式斜率更大。对湍流特性分析发现，双射流的主要动量传递发生在混合区，喷口间距增大，混合区与喷口的距离增加。

Abstract

Flow and mixing characteristics of two parallel jets were studied using PIV measurements at different velocities and distances between centers of two nozzles.The results showed that absolute velocity along symmetric line rose but the point of maximum combined velocity barely changed as velocities at nozzle exits were increased.With distance increase between two nozzles

the parallel jets displayed delay in merging process

moving down of combining point

decrease of momentum transported to the symmetric line

and reduce of maximum velocity at combining point.A linear relationship was observed between the spacing ratio and the combining point.Compared to large spacing ratio

small spacing ratio had more obvious impact on the combining point and thus the slope was larger.The turbulence characteristics indicated that main momentum transfer between the two parallel jets occurred in the merging region.As the spacing between two jets was increased

the merging region moved away from nozzle exits.

关键词

Keywords

references

Views

214

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Numerical study on vortex characteristics in submerged impinging stream reactor

Investigation of secondary flow in helical coils based on residence time distribution

A capacitance sensor with hydrocyclone phase separator for measuring water volume fraction in gas-liquid two-phase flow

Thermo-gas-elastic coupling performance analysis of high-speed and high-temperature foil face seals

Identification of gas-liquid two-phase flow patterns in a riser based on recursive characteristics and CNN

Related Author

Jianwei ZHANG

Weifeng GAO

Xin DONG

Ying FENG

Zhengliang HUANG

Chao WANG

Yanni GUO

Yao YANG

Related Institution

School of Mechanical and Power Engineering, Shenyang University of Chemical Technology

State Key Laboratory of Chemical Engineering, Zhejiang University

Zhejiang Provincial Key Laboratory of Advanced Chemical Engineering Manufacture Technology

College of Chemical and Biological Engineering, Zhejiang University

School of Electrical and Information Engineering, Tianjin University

⁰