Running performance of working fluid pump for organic Rankine cycle system

ZHANG Hongguang; YANG Yuxin; MENG Fanxiao; ZHAO Rui; TIAN Yaming; LIU Yi

doi:10.11949/j.issn.0438-1157.20170244

您当前的位置：

首页 >

文章列表页 >

Running performance of working fluid pump for organic Rankine cycle system

更新时间：2025-12-10

- Running performance of working fluid pump for organic Rankine cycle system
- CIESC Journal Issue 9, Pages: 3573-3579(2017)
- 作者机构：
  
  1. 北京工业大学环境与能源工程学院,北京,100124
  2. 北京电动车辆协同创新中心,北京,100124
  3. 大同北方天力增压技术有限公司,山西,大同,037036
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20170244
  CLC： K115
- Online First：05 September 2017，
  
  Published：05 September 2017
- 稿件说明：
移动端阅览
ZHANG Hongguang, YANG Yuxin, MENG Fanxiao, et al. Running performance of working fluid pump for organic Rankine cycle system[J]. CIESC Journal, 2017, (9): 3573-3579.
DOI：

ZHANG Hongguang, YANG Yuxin, MENG Fanxiao, et al. Running performance of working fluid pump for organic Rankine cycle system[J]. CIESC Journal, 2017, (9): 3573-3579. DOI： 10.11949/j.issn.0438-1157.20170244.

摘要

为研究车用有机朗肯循环（organic Rankine cycle，ORC）余热回收系统中工质泵的性能及选型，在模拟车用ORC余热回收系统的工作环境下，设计并搭建了以R123作为工质的多级离心泵性能测试实验系统。通过控制多级离心泵转速（870~2900 r·min-1）、调节工质流量（0.20~5.00 m3·h-1），得到了多级离心泵特性曲线。通过分析变工况时多级离心泵关键参数间相互作用关系，及其对车用ORC余热回收系统性能的影响情况，验证了多级离心泵应用于车用ORC余热回收系统的可行性，并确定了其最佳工况点参数。研究结果表明：变工况时，多级离心泵总效率为15.00%~65.70%。车用ORC余热回收系统的蒸发压力、热效率均随着多级离心泵转速的增加而增加。在高转速区，工质流量对系统蒸发压力和多级离心泵输入功率（多级离心泵消耗的电功率）的影响明显增大。随着系统蒸发温度的升高，工质泵实际输入功率占膨胀机输出功率的比例（back work ratio，BWR）最高可达0.45。当多级离心泵转速为2900 r·min-1时，车用ORC余热回收系统热效率最高可达10.50%。

Abstract

To study the performance and selection of the working fluid pump in organic Rankine cycle (ORC) waste heat recovery system for vehicle engines

a test bench of a multistage centrifugal pump was constructed using R123 as working fluid in a condition of simulative ORC waste heat recovery system for vehicle engines. Experimental results of the multistage centrifugal pump under various operating conditions were obtained based on controlled working rotational speed (870-2900 r·min-1) and working fluid flow rate (0.20-5.00 m3·h-1). The interaction of the key pump parameters and their effect on the ORC performance were analyzed in this paper. In addition

the feasibility of the multistage centrifugal pump applied to the ORC waste heat recovery system for vehicle engines was verified and the optimal working point parameters were also determined. Results showed that the overall pump efficiency of multistage centrifugal pump was between 15.00% and 65.70%. The outlet pressure

pump efficiency and ORC thermal efficiency increased with the increase of the rotating speed of the pump. The flow rate needed to be regulated as the frequency became increasingly high. The maximum thermal efficiencies of the ORC system corresponding to various working frequencies of the pump were observed. Furthermore

the practical back work ratio (BWR) can reach up to 0.45 with the increase of the evaporating temperature of the ORC system. And the thermal efficiency can reach up to 10.50% when the rotating speed of multistage centrifugal pump was 2900 r·min-1. Pumping power should not be neglected for small-scale ORC applications

and pump efficiency assumptions should be dependent on experiments. Low pump efficiency affected the increase of the thermal efficiency and net power of the ORC system.

关键词

Keywords

references

Views

338

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Effect of cold source temperature on power generation of small organic Rankine cycle system with low-grade waste heat

Environmental analysis of biomass double-stage evaporation double-regenerative organic Rankine cycle system

Working fluid screening and thermodynamic optimization of hazardous waste incineration coupled organic Rankine cycle system

Multi-objective optimization of Rankine cycle using R245fa/pentane based on liquid-vapor separation

Thermo-economic performance analysis of Kalina cycle based on low temperature flue gas waste heat power generation

Related Author

XIE Feibo

ZHU Tong

GAO Naiping

DAI Wenzhi

SHEN Xiongjian

SONG Xiaobo

YANG Xinle

ZHANG Manzheng

Related Institution

School of Mechanical Engineering, Tongji University

School of Mechanical Engineering, Liaoning University of Technology

Beijing Key Laboratory of Multi-phase Flow and Heat Transfer of Low-grade Energy (North China Electric Power University)

Institute of Materials and Energy, Guangdong University of Technology, Gunagzhou

Key Laboratory of Low-Grade Energy Utilization Technologies and Systems, Ministry of Education, Chongqing University

⁰