Heating performance of single cylinder vapor injection rotary compressor applying in air-source heat pump system

SUN Jinfei; ZHU Dongsheng; YIN Yingde; LI Xiuzhen; TU Aimin

doi:10.11949/j.issn.0438-1157.20170171

您当前的位置：

首页 >

文章列表页 >

Heating performance of single cylinder vapor injection rotary compressor applying in air-source heat pump system

更新时间：2025-12-10

- Heating performance of single cylinder vapor injection rotary compressor applying in air-source heat pump system
- CIESC Journal Issue 9, Pages: 3551-3557(2017)
- 作者机构：
  
  1. 中国科学院广州能源研究所,广东,广州,510640
  2. 中国科学院可再生能源重点实验室,广东,广州,510640
  3. 广东省新能源和可再生能源研究开发与应用重点实验室,广东,广州,510640
  4. 中国科学院大学,北京,100049
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20170171
  CLC： B61+5
- Online First：05 September 2017，
  
  Published：05 September 2017
- 稿件说明：
移动端阅览
SUN Jinfei, ZHU Dongsheng, YIN Yingde, et al. Heating performance of single cylinder vapor injection rotary compressor applying in air-source heat pump system[J]. CIESC Journal, 2017, (9): 3551-3557.
DOI：

SUN Jinfei, ZHU Dongsheng, YIN Yingde, et al. Heating performance of single cylinder vapor injection rotary compressor applying in air-source heat pump system[J]. CIESC Journal, 2017, (9): 3551-3557. DOI： 10.11949/j.issn.0438-1157.20170171.

摘要

利用中间补气技术将单缸滚动转子式压缩机应用于空气源热泵系统中，系统地研究以R410A为冷媒的热泵系统在变频、变补气压力工况下制热性能的变化规律。实验结果表明：中间补气系统的制热量及系统功率均随着压缩机频率f、中间补气压力pinj的增加呈上升趋势，同频率下系统功率则以线性方式增长，而系统制热量随着补气压力及频率的增大，其相对增长率逐渐减小。因此COPh在低频时存在最佳补气压力，而在高频时无极值点；与单级压缩系统相比，在800~1200 kPa、50~80 Hz范围内，中间补气系统的制热量、功率、COPh最大提升分别为27.55%、30.75%、7.1%。随着频率及补气压力的增加，系统COPh下降，因此中间补气技术应与合理的控制策略相结合，可使中间补气系统达到节能高效的目的。

Abstract

A novel single cylinder rotary compressor

which was increased a vapor injection hole near the discharge port

was adopted to improve the heating performance of a flash tank vapor injection air-source heat pump (FTHP) system at low ambient temperature. The effects of compressor frequency f and injection pressure pinj on system performances of a R410A FTHP system were measured and investigated systematically. The results showed that both heating capacity and power consuming of the FTHP system increased with increasing the compressor frequency and injection pressure. The FTHP system power consuming at fixed frequency increased linearly with increasing injection pressure. The increasing rate of FTHP system heating capacity declined as the frequency and injection pressure increased. Therefore

the heating COPh had a peak value at certain injection pressure when the frequency was low. After the peak point or at high frequency

the heating COPh decreased as the frequency and injection pressure increased. In the range of 800 kPa to 1200 kPa and 50 Hz to 80 Hz

the maximum improvement of the FTHP heating capacity

power consuming

and COPh were 27.55%

30.75% and 7.1%

respectively

compared to the single stage compression system. In order to make the FTHP system efficiently

the control strategy must be optimized to keep the system operated at the optimum injection pressure and frequency.

关键词

Keywords

references

Views

230

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Experimental investigation on heating performance of vapor-injection CO2 heat pump for electric vehicles at -30℃

Heating performance of recuperative heat pump using low-GWP mixed refrigerant

Impact of defrost falling water on defrost performance of heat exchanger

Performance investigation of air-source heat pump heating system with novel thermal storage refrigerant-heated panel

Analysis of heating performance of CO2 air-source heat pump in cold region

Related Author

TIAN Changqing

WANG Chunlei

ZHOU Hui

YANG Tianyang

ZOU Huiming

Jielin LUO

Kaiyin YANG

Zhen ZHAO

Related Institution

Key Laboratory of Technology on Space Energy Conversion, Technical Institute of Physics and Chemistry, Chinese Academy of Sciences

Songz Automobile Air Conditioning Co., Ltd.

Institute of Refrigeration and Cryogenics, Zhejiang University

School of Energy Science and Engineering, Central South University

School of Environmental Science and Engineering, Tianjin University

⁰