GE Yaxin, ZHANG Guangyi, CUI Lijie, et al. Characteristics of NOx and SO2 emission from combustion of antibiotic mycelial residue with high water content in fluidized bed reactor[J]. CIESC Journal, 2017, (8): 3250-3257. DOI: 10.11949/j.issn.0438-1157.20170035.
DOI:
GE Yaxin, ZHANG Guangyi, CUI Lijie, et al. Characteristics of NOx and SO2 emission from combustion of antibiotic mycelial residue with high water content in fluidized bed reactor[J]. CIESC Journal, 2017, (8): 3250-3257. DOI: 10.11949/j.issn.0438-1157.20170035.DOI:
Characteristics of NOx and SO2 emission from combustion of antibiotic mycelial residue with high water content in fluidized bed reactor
The characteristics of NOx and SO2 emission from combustion of antibiotic mycelial residue with high water content in a fluidized bed reactor were studied. The results showed that with the increase in excess air ratio
the NOx emission concentration increased while the SO2 emission concentration decreased. Enhancing the combustion temperature led to the increases in both the NOx and SO2 emission concentrations. With increasing fuel moisture content
both the NOx and SO2 emission concentrations first decreased and then increased. The air-staging combustion enabled good control of NOx emission. The NOx emission concentration was significantly lower with increasing the secondary air ratio. At the secondary air ratio 3/7
the air-staging combustion cut the NOx emission amount off by more than 50% compared to the traditional combustion. Desulfurization by adding CaCO3 into the furnace indicated that the SO2 emission concentration decreased with increasing molar ratio of calcium to sulfur (Ca/S)
and when Ca/S 3
the SO2 emission concentration decreased to below 25 mg·m-3 and the sulfur removal efficiency surpassed 99%.