Visualization study on flow pattern of gas-liquid two-phase flowing through multi-orifice plate in horizontal pipe

PENG Jiewei; MA Youfu; WU Hengliang; LÜ Junfu; LIU Yuan; PENG An; JIAO Qianfeng

doi:10.11949/j.issn.0438-1157.20161726

您当前的位置：

首页 >

文章列表页 >

Visualization study on flow pattern of gas-liquid two-phase flowing through multi-orifice plate in horizontal pipe

更新时间：2025-12-10

- Visualization study on flow pattern of gas-liquid two-phase flowing through multi-orifice plate in horizontal pipe
- CIESC Journal Issue 6, Pages: 2266-2274(2017)
- 作者机构：
  
  1. 上海理工大学能源与动力工程学院,上海,200093
  2. 清华大学热科学与动力工程教育部重点实验室,北京,100084
  3. 中国船舶重工集团公司第七一一研究所,上海,200090
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20161726
  CLC： 359+.1
- Online First：05 June 2017，
  
  Published：05 June 2017
- 稿件说明：
移动端阅览
PENG Jiewei, MA Youfu, WU Hengliang, et al. Visualization study on flow pattern of gas-liquid two-phase flowing through multi-orifice plate in horizontal pipe[J]. CIESC Journal, 2017, (6): 2266-2274.
DOI：

PENG Jiewei, MA Youfu, WU Hengliang, et al. Visualization study on flow pattern of gas-liquid two-phase flowing through multi-orifice plate in horizontal pipe[J]. CIESC Journal, 2017, (6): 2266-2274. DOI： 10.11949/j.issn.0438-1157.20161726.

摘要

多孔板后是否形成均匀分散的泡状流流型是影响多孔板废气吸收装置吸收效果的关键因素。以空气和水作为两相介质，对气液两相混合物在水平管内流经多孔板后形成的流型进行实验。通过孔径分别为2、3、4、5 mm的4只多孔板在内径98.5 mm水平有机玻璃管内的可视化流动及高速摄像，研究了孔径大小、气相流量变化及液相流量变化对多孔板后流型的影响规律。实验结果表明：水平管内插入多孔板后，分层/塞状流转变边界向液相流量增大方向推移，塞状/泡状流转变边界向液相流量减小方向推移；随气相流量减小或液相流量增大，多孔板后流型趋于形成泡状流；孔径大小对多孔板后流型具有重要影响，减小孔径使塞状/泡状流转变边界移向更大气相流量和更小液相流量，即形成泡状流的两相流量范围增大；随孔径减小，孔板后流型趋于由分层流直接过渡至泡状流，塞状流趋于消失。为保证多孔板吸收装置的良好流型和吸收效果，建议多孔板孔径不大于3 mm。

Abstract

Producing a bubble flow in multi-orifice plate downstream (MOPD) is a basic condition for the exhaust absorber with multi-orifice plates to achieve a satisfied absorption capacity. In this paper

a visualization experiment on the flow pattern of gas-liquid two-phase flowing through a multi-orifice plate in a horizontal pipe was conducted using the air and water as the gas and liquid phase

respectively. Four multi-orifice plates with the orifice diameter of 2

4 and 5 mm were tested in a horizontal plexiglass pipe with the inner diameter of 98.5 mm by using a high speed camcorder to record the air-water flow

thus the effects of orifice diameter

air flow rate and water flow rate on the flow pattern in the multi-orifice plate downstream were obtained. The results show that the stratified/plug flow transition in MOPD shift to an increased water flow rate while the plug/bubble flow transition shift to a decreased water flow rate in comparison with the flow pattern transition in horizontal pipes. The flow pattern in MOPD is inclined to a bubble flow with the decrease of air flow rate or the increase of water flow rate. Meanwhile

an important dependence on the orifice diameter is found for the flow pattern in MOPD. With the decrease of orifice diameter

the plug/bubble flow transition shift to an increased air flow rate and a decreased water flow rate

meaning that an increased flow range is obtained to form bubble flow. In addition

as the orifice diameter decreasing

the flow pattern in MOPD is inclined to transfer from wavy stratified flow to bubble flow directly without an occurrence of plug flow. To achieve a satisfied flow pattern and absorption capacity for the exhaust absorber with multi-orifice plates

it is recommended to choose the orifice diameter not larger than 3 mm.

关键词

Keywords

references

Views

386

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Analysis of the effect of air injection hole position on bubble formation characteristics of Venturi-type microbubble generator

Migration behavior of bubble cluster emerging from micro-orifice with liquid cross flow in mini-channel

Gas-liquid flow distribution of parallel microchannels

Oxygen mass transfer performance of hollow fiber non-bubble aeration membrane based on gas/liquid-phase measurement method

Controlled synthesis of Bi2MoO6/MoO3 composite fibers via in-situ hydrothermal method and their high-efficiency photocatalytic hydrogen production performance

Related Author

Guodong DING

Jiaqing CHEN

Zhenlin LI

Xiaolei CAI

ZHU Xun

XIE Jian

WANG Hong

LIAO Qiang

Related Institution

College of Mechanical Engineering, Beijing Institute of Petrochemical Technology

College of Mechanical and Transportation Engineering, China University of Petroleum

Beijing Key Laboratory of Pipeline Critical Technology and Equipment for Deep Water Oil & Gas Development

Key Laboratory of Low-grade Energy Utilization Technologies and Systems, Chongqing University

Institute of Engineering Thermophysics, Chongqing University

⁰