Liquid level optimal-setting for alumina multi-effect evaporation process based on exergy analysis

ZUO Jian; XIE Yongfang; WANG Xiaoli; WANG Feng; YANG Chunhua

doi:10.11949/j.issn.0438-1157.20161689

您当前的位置：

首页 >

文章列表页 >

Liquid level optimal-setting for alumina multi-effect evaporation process based on exergy analysis

更新时间：2025-12-10

- Liquid level optimal-setting for alumina multi-effect evaporation process based on exergy analysis
- CIESC Journal Issue 3, Pages: 1005-1013(2017)
- 作者机构：
  
  中南大学信息科学与工程学院,湖南,长沙,410083
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20161689
  CLC： F821
- Online First：05 March 2017，
  
  Published：05 March 2017
- 稿件说明：
移动端阅览
ZUO Jian, XIE Yongfang, WANG Xiaoli, et al. Liquid level optimal-setting for alumina multi-effect evaporation process based on exergy analysis[J]. CIESC Journal, 2017, (3): 1005-1013.
DOI：

ZUO Jian, XIE Yongfang, WANG Xiaoli, et al. Liquid level optimal-setting for alumina multi-effect evaporation process based on exergy analysis[J]. CIESC Journal, 2017, (3): 1005-1013. DOI： 10.11949/j.issn.0438-1157.20161689.

摘要

在拜耳法生产氧化铝多效蒸发过程中，各蒸发器液位是影响流程各个参数的重要变量，对整个蒸发过程的优化操作十分重要。但实际生产中各效蒸发器液位的设定值通常是一个较大的范围，难以优化运用。针对此问题提出了一种基于(火用)分析的多效蒸发流程液位优化设定方法。在对液位作用机理分析的基础上，基于整个流程的实际生产数据，拟合得到了每效包含液位随其他参数变化的关系模型。结合蒸发流程物料平衡关系以及(火用)分析方法，建立了综合(火用)效率评价指标的能耗优化模型。最后，采用两种不同约束处理技术和状态转移算法，计算了不同酸洗周期下的各效蒸发器最优液位，得到了优化目标随各个效液位高度变化的关系曲线。

Abstract

In the multi-effect evaporation process in Bayer process for alumina production

liquid level of each effect is an important parameter that influences other parameters and important for optimization of evaporator operation. But in the actual production

the liquid level is usually set empirically in a large rang

so that the process cannot run in optimal situation. This paper proposed a liquid level optimization method based on exergy analysis. By deeply analyzing the liquid level's effect on other evaporation parameters and using the actual running data

the relationships between liquid level and other parameters are obtained. Combining the material balance of the evaporator and the exergy analysis method

optimization model for energy consumption based on the maximum exergy efficiency is established. The optimization model is then solved by STA using two different constraint handling technology under a certain condition to get better solutions. Finally the optimal level under three different pickling cycle is calculated and evaporation liquid level curve for each effect is obtained.

关键词

Keywords

references

Views

199

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Optimization method of double-stream alumina digestion process parameters

Simulation of sessile nanofluid droplet evaporation character

Multi-delays identification for alumina evaporation process based on time-correlation analysis

Multi-objective optimal strategy for steam power system in steel industry based on electricity equivalent calculation

Multi objective optimization of flow and heat transfer characteristics of modified manifold microchannel heat sink based on machine learning

Related Author

YAN Yuqing

XIE Yongfang

WANG Xiaoli

WEI Simi

ZHANG Xingchan

Ming JIN

Dinghua HU

Qiang LI

Related Institution

MIIT Key Laboratory of Thermal Control of Electronic Equipment, Nanjing University of Science and Technology

School of Mechanical Engineering, Tongji University

School of Mechanical and Power Engineering, Zhengzhou University

BK21 FOUR ERICA-ACE Center, Hanyang University

School of Mechanical and Storage and Transportation Engineering, China University of Petroleum

⁰