Simulate verification of CO<sub>2</sub> microchannel evaporator pressure drop

LÜ Jing; LI Chang; SHI Dongdong; CHEN Qi

doi:10.11949/j.issn.0438-1157.20161165

您当前的位置：

首页 >

文章列表页 >

Simulate verification of CO₂ microchannel evaporator pressure drop

更新时间：2025-12-10

- Simulate verification of CO₂ microchannel evaporator pressure drop
- CIESC Journal Issue 5, Pages: 1866-1873(2017)
- 作者机构：
  
  1. 上海理工大学环境与建筑学院,上海,200093
  2. 中国建筑科学研究院上海分院,上海,200023
  3. 天津三电汽车空调有限公司,天津,300385
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20161165
  CLC： K124
- Online First：05 May 2017，
  
  Published：05 May 2017
- 稿件说明：
移动端阅览
LÜ Jing, LI Chang, SHI Dongdong, et al. Simulate verification of CO₂ microchannel evaporator pressure drop[J]. CIESC Journal, 2017, (5): 1866-1873. DOI: 10.11949/j.issn.0438-1157.20161165.
DOI：

LÜ Jing, LI Chang, SHI Dongdong, et al. Simulate verification of CO₂ microchannel evaporator pressure drop[J]. CIESC Journal, 2017, (5): 1866-1873. DOI: 10.11949/j.issn.0438-1157.20161165. DOI：

摘要

分析二氧化碳微通道蒸发器的物理结构及二氧化碳两相段及过热段的流动特性，基于有限元分析法，采用分段研究的方法建立微通道二维分布参数模型。研究各参数对二氧化碳在微通道中流动特性的影响，根据模拟结果可得压降主要发生在蒸发器入口经集流管进入扁管处，二氧化碳在过热段压降远小于两相段压降。蒸发压力对扁管内的压降影响很小，随着二氧化碳质量流率增大，压降增大，两相区与过热区分界线右移。对比分析模拟与实验结果，误差在10%之内，验证所建立数学模型的合理性。

Abstract

This research aims at analyzing the physical structure of CO2 microchannel evaporator and the fluidity of CO2 at two-phase segment and overheat segment. Based on the finite element analysis and the method of segmentation study

the researcher established the microchannel two-dimensional distribution model. The model simulation show that pressure drop mainly happens at the junction of header pipe and flat tube. Pressure drops more at overheat segment than at two-phase segment. Influence of evaporating pressure to the pressure drop of CO2 at flat tube is small. Boundary line between two-phase segment and overheat segment shifts right

when the CO2 flow rate increases and the pressure drop grows. Comparative analysis of simulation and experimental results show the error is within 10%

which verifies the reliability of the established model.

关键词

Keywords

references

Views

199

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Effect of lubricating oil on convective heat transfer characteristics of supercritical carbon dioxide

Entropy analysis of CO2-air microchannel evaporator in two-phase flow region

Simulation study of subcooled flow boiling in wedge-shaped manifold microchannels

Study on the effectiveness of DF model in large eddy simulations of gas-solid two phase turbulence

Numerical simulation study on particle orientation and anisotropic thermal conductivity in magnetic nanofluids

Related Author

XU Wenjie

LI Minxia

GUO Qiang

SHI Dongdong

XU Feng

ZHU Siqian

MA Zihuan

YANG Xiaoping

Related Institution

Key Laboratory of Efficient Utilization of Low and Medium Grade Energy(Tianjin University), Ministry of Education

School of Chemical Engineering and Technology, Xi’an Jiaotong University

State Key Laboratory of Coal Combustion, Huazhong University of Science and Technology

School of Chemistry and Chemical Engineering, South China University of Technology

Department of Materials Science, Lomonosov Moscow State University, Leninskie Gory, 1b73

⁰

Simulate verification of CO2 microchannel evaporator pressure drop

DOI：10.11949/j.issn.0438-1157.20161165

摘要

Abstract

关键词

Keywords

references

Simulate verification of CO₂ microchannel evaporator pressure drop