Effect of latex concentration in ABS resin wastewater on demulsification

LUO Meng; SONG Yudong; ZHENG Shengzhi; ZHOU Yuexi; HE Xuwen

doi:10.11949/j.issn.0438-1157.20160649

您当前的位置：

首页 >

文章列表页 >

Effect of latex concentration in ABS resin wastewater on demulsification

更新时间：2025-12-10

- Effect of latex concentration in ABS resin wastewater on demulsification
- CIESC Journal Issue 11, Pages: 4837-4842(2016)
- 作者机构：
  
  1. 中国矿业大学(北京)化学与环境工程学院,北京,100083
  2. 中国环境科学研究院水污染控制技术研究中心,北京,100012
  3. 中国环境科学研究院环境基准与风险评估国家重点实验室,北京,100012
  4. 北京师范大学水科学研究院,北京,100875
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20160649
  CLC： 783.2
- Online First：05 November 2016，
  
  Published：05 November 2016
- 稿件说明：
移动端阅览
LUO Meng, SONG Yudong, ZHENG Shengzhi, et al. Effect of latex concentration in ABS resin wastewater on demulsification[J]. CIESC Journal, 2016, (11): 4837-4842.
DOI：

LUO Meng, SONG Yudong, ZHENG Shengzhi, et al. Effect of latex concentration in ABS resin wastewater on demulsification[J]. CIESC Journal, 2016, (11): 4837-4842. DOI： 10.11949/j.issn.0438-1157.20160649.

摘要

以ABS树脂接枝聚合工段废水为研究对象，聚合氯化铝（PAC）为破乳剂，考察了胶乳浓度对破乳效果的影响。结果表明，不同胶乳浓度下均存在优化的药剂投加量区间，投加量过小或过大均会造成破乳效果不佳。随着胶乳COD浓度由13012 mg·L-1下降至192 mg·L-1，单位胶乳COD的优化药剂投加量由6.1~10.8 mg·g-1增加至7.7~13.8 mg·g-1，区间向右移动，最佳COD去除率由99.30%下降至91.24%。稀释前后最优单位胶乳COD的药剂投加量提高了40%左右。PAC对ABS树脂废水胶乳的破乳机理以吸附-电性中和为主，随着PAC投加量的增加，胶粒Zeta电位逐渐升高，Zeta电位在-23~13 mV范围内，胶乳可有效破乳。

Abstract

The effect of latex concentration in ABS resin emulsion graft section wastewater on demulsification efficiency was investigated with PAC as demulsifier. The results indicated that there were optimized ranges of reagent dosage in different latex concentrations

as the undersize or oversize dosages could all lead to poor demulsification efficiency. When the latex COD concentration decreased from 13012 mg·L-1 to 192 mg·L-1

the optimized ranges of reagent dosage moved right

increasing from 6.1-10.8 mg·g-1 to 7.7-13.8 mg·g-1. The optimum COD removal efficiencies dropped from 99.30% to 91.24%. The optimum reagent dosages per latex COD unit increased by about 40%. The demulsification mechanism of latex wastewater by PAC was mainly adsorption-charge neutralization. With increase of PAC dosage

the colloid Zeta potential increased

and the latex could realize demulsification effectively in the range of -23-13 mV.

关键词

Keywords

references

Views

150

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Research on demulsification of O/W emulsion by spiral plate microchannel with ultra-large aspect ratio

Study on preparation and performance of aqueous binder for lithium iron phosphate electrodes in lithium-ion battery

Study on boiling characteristics of liquid crystal elastomer surfaces with thermally adaptive wettability

Numerical study on damage behavior of rubber O-ring seals under hydrogen-friction coupling effects

Study on synergistic modification of nitrogen-doped carbon coating and Ti⁴⁺ co-doping for lithium vanadium phosphate cathode materials

Related Author

Zhengdong MA

Meixiu WEI

Qilin LU

DILIYAER∙Hamiti

Xiao CHEN

Jianing CAO

Xiang GAO

Yingwu LUO

Related Institution

Key Laboratory of Basic Chemistry, State Ethnic Affairs Commission, College of Chemistry & Environment, Southwest Minzu University

Microfluidic Synthesis and Separation Laboratory, College of Chemistry & Environment, Southwest Minzu University

State Key Laboratory of Chemical Engineering, College of Chemical and Biological Engineering, Zhejiang University

Institute of Zhejiang University-Quzhou

State Key Laboratory of Chemical Engineering, School of Chemical Engineering and Technology, Tianjin University

⁰