Numerical simulation on flow boiling heat transfer of R32 in micro/mini-channels

ZHAO Ran; WU Xiaomin; HUANG Xiujie

doi:10.11949/j.issn.0438-1157.20160643

您当前的位置：

首页 >

文章列表页 >

Numerical simulation on flow boiling heat transfer of R32 in micro/mini-channels

更新时间：2025-12-10

- Numerical simulation on flow boiling heat transfer of R32 in micro/mini-channels
- CIESC Journal Issue S1, Pages: 33-39(2016)
- 作者机构：
  
  清华大学热能工程系, 热科学与动力工程教育部重点实验室,北京,100084
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20160643
  CLC： K124
- Online First：31 August 2016，
  
  Published：31 August 2016
- 稿件说明：
移动端阅览
ZHAO Ran, WU Xiaomin, HUANG Xiujie. Numerical simulation on flow boiling heat transfer of R32 in micro/mini-channels[J]. CIESC Journal, 2016, (S1): 33-39.
DOI：

ZHAO Ran, WU Xiaomin, HUANG Xiujie. Numerical simulation on flow boiling heat transfer of R32 in micro/mini-channels[J]. CIESC Journal, 2016, (S1): 33-39. DOI： 10.11949/j.issn.0438-1157.20160643.

摘要

利用VOF多相流模型对R32在1、2 mm水平光管内流动沸腾换热进行了二维非稳态数值模拟。模拟的工况为：质量流速100 kg·m2·s-1，热通量12 kW·m-2，饱和温度15℃。模拟结果显示：2 mm通道内工质的流动沸腾过程依次经历了液相单相流、泡状流、弹状流；1 mm通道内工质的流动沸腾过程依次经历了液相单相流、泡状流、受限泡状流、弹状流。利用模拟所得气相体积分数分布、温度分布，分析了R32管内流动沸腾过程中的基本规律和气泡运动特点，以及管径对流动沸腾换热过程流型的影响。利用数值模拟结果与实验结果进行对比，显示较好的一致性。

Abstract

Two dimensional unsteady numerical simulations of flow boiling heat transfer inside a 1 mm and 2 mm smooth horizontal tubes for R32 were conducted utilizing VOF multiphase model

under the condition of a mass flux of 100 kg·m-2·s-1

a heat flux of 12 kW·m-2

a saturation temperature of 15℃. Single phase flow

bubbly flow

slug flow were observed in the simulation results for R32 flow boiling heat transfer inside a 2 mm channel while single phase flow

bubbly flow

confined bubbly flow

slug flow were observed inside a 1 mm channel. Bubble movement characters and influences on flow boiling heat transfer basic patterns exerted by channel diameter during flow boiling heat transfer inside the tubes for R32 were analyzed based on the distributions of gas phase volume fraction and temperature generated by the simulations. A promising consistency was achieved through the comparison between numerical simulation and experimental results.

关键词

Keywords

references

Views

222

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Numerical study on heat and mass transfer characteristics of particle coating in a spray fluidized bed with draft plates

Numerical simulation for flow condensation of methanol in horizontal tube

Liquid-liquid mixing characteristics of Bunsen reaction products in microchannels

Electrolyte flow characteristics of seawater activated battery

Application of physics-informed neural network in two-phase flow

Related Author

DENG Aiming

HE Yurong

TANG Tianqi

GUO Jiangyue

CHANG Shoujin

HU Haitao

ZHANG Ke

REN Weijie

Related Institution

School of Energy Science and Engineering, Harbin Institute of Technology

Zhengzhou Research Institute, Harbin Institute of Technology

Heilongjiang Key Laboratory of New Energy Storage Materials and Processes

School of Mechanical Engineering, Shanghai Jiao Tong University

College of Environment and Resources, Taiyuan University of Science and Technology

⁰