Method of optical fiber measurement for local particle flux and velocity in riser

WANG Fenfen; E Chenglin; ZHAO Aihong; LU Chunxi

doi:10.11949/j.issn.0438-1157.20160393

您当前的位置：

首页 >

文章列表页 >

Method of optical fiber measurement for local particle flux and velocity in riser

更新时间：2025-12-10

- Method of optical fiber measurement for local particle flux and velocity in riser
- CIESC Journal Issue 8, Pages: 3209-3223(2016)
- 作者机构：
  
  中国石油大学(北京)重质油国家重点实验室,北京,102249
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20160393
  CLC： Q051.11
- Online First：05 August 2016，
  
  Published：05 August 2016
- 稿件说明：
移动端阅览
WANG Fenfen, E Chenglin, ZHAO Aihong, et al. Method of optical fiber measurement for local particle flux and velocity in riser[J]. CIESC Journal, 2016, (8): 3209-3223.
DOI：

WANG Fenfen, E Chenglin, ZHAO Aihong, et al. Method of optical fiber measurement for local particle flux and velocity in riser[J]. CIESC Journal, 2016, (8): 3209-3223. DOI： 10.11949/j.issn.0438-1157.20160393.

摘要

在一套高约18 m、内径φ100 mm的提升管冷态实验装置上，根据PV-6D光纤探头的测量结果，提出了一种基于整个采样时间计算提升管颗粒局部流率和速度的改进方法，并与文献方法进行了对比。结果表明，两种方法计算的颗粒局部流率和速度相差较大，本文和文献两种方法计算的截面平均颗粒流率与实测值间的最大、最小和平均相对偏差分别为606.9%、241.3%，221.4%、89.5%和388.9%、145.6%，本文方法测量的颗粒流率偏差相对较小。文献方法计算的截面平均颗粒速度均大于操作气速，其气固间滑落速度和滑落系数分别在-1.6～-4.7 m·s-1及0.56～0.90间变化，与提升管内的气固实际流动存在很大差别；本方法计算的截面平均颗粒速度均小于操作气速，其气固间滑落速度和滑落系数分别在0.6～9.6 m·s-1及1.11～2.14间变化。反射型光纤探头在测量颗粒浓度时存在的一些问题是导致本文方法测量的颗粒流率、滑落速度和滑落系数偏大的主要原因。此外，根据光纤测量结果，提出了两个计算提升管颗粒循环强度的关系式，可以替代现有的容积法测量。

Abstract

A new method was proposed in a cold riser experimental apparatus with height of about 18 m and inner diameter of 100 mm according to the result measured by PV-6D optical fiber to calculate the local particle flux and velocity based on all the sampling time. The new method was compared with the method used in the referring paper. The results showed that the values of local particle flux and velocity calculated by the two methods had a great discrepancy. The maximum

minimum and mean relative errors between the cross-sectional mean particle flux and the measured value calculated by this paper and the referring paper were 606.9%

241.3%; 221.4%

89.5% and 388.9%

145.6%

respectively. Thus

the value of particle flux measured by this paper was relatively low. The cross-sectional mean particle velocity calculated by the referring paper was higher than the operating gas velocity

and the gas-solid slip velocity and slip coefficient respectively varied from -1.6 to -4.7 m·s-1 and 0.56 to 0.90

respectively

and thus there was a great difference to the actual gas-solid flow in riser. The cross-sectional mean particle velocity calculated by this paper was lower than the operating gas velocity. The gas-solid slip velocity and slip coefficient varied from 0.6 to 9.6 m·s-1 and 1.11 to 2.14

respectively. There were some problems when using the reflecting optical fiber to measure the particle concentration and it was the main reason that resulted in the higher particle flux

slip velocity and slip coefficient measured by this paper. Furthermore

two fitting functions were come up with to calculate the particle circulation in the riser according to the measuring result by the optical fiber

substituting for the recent volumetric method.

关键词

Keywords

references

Views

161

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Particle velocity and residence time distributions in pre-stripper section of circulating stripping vortex quick separator system

Study on the pressure pulsation characteristics in jet influence zone of riser

Regulation and industrial application of gas jet hydrodynamic behavior in a feedstock injection zone of a riser

Numerical simulation study on influence of mesoscale structure in riser reactor

Effects of inlet distributor on particle flow characteristics in 18 m circulating fluidized bed riser

Related Author

ZHAO Aihong

E Chenglin

WANG Fenfen

LU Chunxi

ZHENG Zhihang

MA Junnan

YAN Zihan

LU Chunxi

Related Institution

State Key Laboratory of Heavy Oil Processing, China University of Petroleum

Shenyang Research Institute of Chemical Industry

Haihe Laboratory of Sustainable Chemical Transformations

Shaanxi Research Center of Engineering Technology for Clean Coal Conversion

School of Chemical Engineering, Northwest University

⁰