Numerical simulation of natural vortex length in riser termination with SVQS system

CHENG Zhaolong; E Chenglin; LU Chunxi

doi:10.11949/j.issn.0438-1157.20160381

您当前的位置：

首页 >

文章列表页 >

Numerical simulation of natural vortex length in riser termination with SVQS system

更新时间：2025-12-10

- Numerical simulation of natural vortex length in riser termination with SVQS system
- CIESC Journal Issue 8, Pages: 3347-3356(2016)
- 作者机构：
  
  中国石油大学(北京)重质油国家重点实验室,北京,102249
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20160381
  CLC： 351TE624TQ021.1
- Online First：05 August 2016，
  
  Published：05 August 2016
- 稿件说明：
移动端阅览
CHENG Zhaolong, E Chenglin, LU Chunxi. Numerical simulation of natural vortex length in riser termination with SVQS system[J]. CIESC Journal, 2016, (8): 3347-3356.
DOI：

CHENG Zhaolong, E Chenglin, LU Chunxi. Numerical simulation of natural vortex length in riser termination with SVQS system[J]. CIESC Journal, 2016, (8): 3347-3356. DOI： 10.11949/j.issn.0438-1157.20160381.

摘要

采用RNG k-ε湍流模型对一套φ600 mm×4150 mm的SVQS旋流快分装置的气相流场及自然旋风长度进行了模拟研究。结果表明，SVQS旋风尾涡的截面位置与隔流筒下端面最大切向速度衰减达88%时的截面位置相吻合，并据此定义了SVQS的自然旋风长度。基于SVQS旋流快分切向速度的分布规律发现，SVQS的自然旋风长度随喷口气速的增加和汽提气速的减小而逐渐增大。参照旋风分离器自然旋风长度的计算方法，基于SVQS旋流快分的结构特点及模拟计算结果，提出了提升管出口SVQS旋流快分自然旋风长度的计算关系式。

Abstract

To optimize the cylinder height of the closing section

the gas phase flow field and the natural vortex length in a φ600 mm×4150 mm super vortex quick separation (SVQS) system were simulated by using the RNG k-ε turbulent model. The simulation results show that the cross-section location of the vortex end was agreeable to that of 88% attenuation of the maximum tangential velocity in the entrance section of flow partition column

which hence defined the natural vortex length. From the tangential velocity distribution of gas phase in SVQS

the natural vortex length of the quick separation was found to increase with the increase of spout velocity and the decrease of stripping velocity. Based on the numerical simulation and structural characteristics of SVQS

an equation for calculating the natural vortex length in SVQS was developed.

关键词

Keywords

references

Views

262

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Desolidification structure and optimization of specially-shaped hydrocyclone three-phase separation device for industrial waste oil

Experimental and numerical investigation on effect of particle characteristics on performance of plate-type impact separator

Numerical simulation of vortex-eliminating plates in super vortex quick separation system at end of catalytic cracking riser

Effect of terminator injection on catalytic cracking reactions in FCC riser

Discrete element simulation of gas-solids flow behavior in riser

Related Author

GONG Haifeng

LUO Xin

PENG Ye

YU Bao

YANG Yang

ZHANG Haohua

FENG Lele

WANG Jingyu

Related Institution

Engineering Research Centre for Waste Oil Recovery Technology and Equipment of Ministry of Education, Chongqing Technology and Business University

Chongqing Key Laboratory of Manufacturing Equipment Mechanism Design and Control, Chongqing Technology and Business University

State Key Laboratory of Heavy Oil Processing, China University of Petroleum

Key Laboratory for Thermal Science and Power Engineering of Ministry of Education, Department of Energy and Power Engineering, Tsinghua University

School of Aerospace and Civil Engineering, Harbin Engineering University

⁰