Characteristics of slip velocity between gas and solid in short-contact cyclone FCC reactor

ZHU Liyun; ZHAO Wenbin; ZHONG Like; ZHANG Yuchun; WANG Zhenbo; JIN Youhai

doi:10.11949/j.issn.0438-1157.20160369

您当前的位置：

首页 >

文章列表页 >

Characteristics of slip velocity between gas and solid in short-contact cyclone FCC reactor

更新时间：2025-12-10

- Characteristics of slip velocity between gas and solid in short-contact cyclone FCC reactor
- CIESC Journal Issue 8, Pages: 3468-3475(2016)
- 作者机构：
  
  1. 中国石油大学(华东)重质油国家重点实验室,山东,青岛,266580
  2. 山东理工大学农业工程与食品科学学院,山东,淄博,255049
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20160369
  CLC： Q051.8
- Online First：05 August 2016，
  
  Published：05 August 2016
- 稿件说明：
移动端阅览
ZHU Liyun, ZHAO Wenbin, ZHONG Like, et al. Characteristics of slip velocity between gas and solid in short-contact cyclone FCC reactor[J]. CIESC Journal, 2016, (8): 3468-3475.
DOI：

ZHU Liyun, ZHAO Wenbin, ZHONG Like, et al. Characteristics of slip velocity between gas and solid in short-contact cyclone FCC reactor[J]. CIESC Journal, 2016, (8): 3468-3475. DOI： 10.11949/j.issn.0438-1157.20160369.

摘要

利用欧拉-欧拉双流体模型对短接触旋流反应器分离腔内气固滑移特性进行了数值模拟，主要研究了切向气固滑移速度的分布规律，并考察了操作参数和物性参数对分离腔内切向滑移速度的影响。计算结果表明，分离腔内切向气固滑移速度沿径向呈“驼峰”分布；当气相入口速度增大或者剂气比减小时，切向气固滑移速度变小，颗粒切向速度增大，离心力增大，有利于提高气固分离效率；颗粒密度对切向滑移速度分布影响不大；颗粒粒径较大时，在排尘口易出现堵塞，不利于长周期运行；建立了截面平均切向气固滑移速度计算模型，计算值与模拟结果误差在±7.0%以内。

Abstract

The characteristics of slip velocity between gas and solid in a short-contact cyclone FCC reactor was simulated using the Eulerian-Eulerian two fluid model

especially about radial distribution of the tangential slip velocity between gas and solid as well as its dependence on operational and physical parameters in the separation chamber. Simulation results showed that the tangential slip velocity between gas and solid had a two-humped distribution in the radial direction. With increase of the inlet gas velocity or decrease of the ratio of catalyst to gas

the tangential slip velocity between gas and solid weakened but the tangential velocity of solid particles enhanced

which would strengthen the centrifugal force on particles and improve the gas-solid separation efficiency. The particle density exhibited little influence on radial distribution of the tangential slip velocity between gas and solid. However

when the particle diameters were increased

the dust outlet would easily be clogged which was not conducive to running the reactor for a long cycle of time. Finally

a model of the average cross-section tangential slip velocity between gas and solid was established with no more than ±7.0% difference among model simulations and calculated results.

关键词

Keywords

references

Views

121

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Life cycle carbon emission and environment assessment of pre-combustion IGCC power plant

Study on the purification technology of 4N electronic-grade diethoxymethylsilane

Process design and energy saving for benzene/cyclohexane/cyclohexene extractive distillation process

Phase equilibrium and separation of n-dodecane-toluene-phenol in low temperature coal tar

Algebraic analysis modeling method for complex reactions

Related Author

CHEN Shiyi

CAO Xinxin

CHEN Shuyi

LI Jixin

XIANG Wenguo

SHI Renze

DING Qiuyan

YUAN Zhenjun

Related Institution

School of Energy and Environment, Southeast University

Institute of Science and Technology for Carbon Neutrality, Southeast University

School of Chemical Engineering and Technology, Tianjin University

National Engineering Research Center of Distillation Technology

China ENFI Engineering Co., Ltd.

⁰