Characteristics of ash deposition on a novel heat transfer surface

LI Jinbo; WANG Peili; CHENG Lin

doi:10.11949/j.issn.0438-1157.20160232

您当前的位置：

首页 >

文章列表页 >

Characteristics of ash deposition on a novel heat transfer surface

更新时间：2025-12-10

- Characteristics of ash deposition on a novel heat transfer surface
- CIESC Journal Issue 9, Pages: 3598-3606(2016)
- 作者机构：
  
  山东大学热科学与工程研究中心,山东,济南,250061
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20160232
  CLC： K124
- Online First：05 September 2016，
  
  Published：05 September 2016
- 稿件说明：
移动端阅览
LI Jinbo, WANG Peili, CHENG Lin. Characteristics of ash deposition on a novel heat transfer surface[J]. CIESC Journal, 2016, (9): 3598-3606.
DOI：

LI Jinbo, WANG Peili, CHENG Lin. Characteristics of ash deposition on a novel heat transfer surface[J]. CIESC Journal, 2016, (9): 3598-3606. DOI： 10.11949/j.issn.0438-1157.20160232.

摘要

以一种余热锅炉中新型的受热面为研究对象，采用实验研究和数值模拟的方法研究其飞灰沉积特性。建立了菱形受热面飞灰颗粒的沉积模型，对飞灰颗粒的反弹、黏附及脱落过程进行预测，并与叉排管束和顺排管束的含灰烟气流的速度场、温度场和飞灰颗粒沉积率进行比较。结果表明，菱形受热面在换热和飞灰沉积方面优势明显。沉积主要集中于受热面左上部，颗粒由于惯性碰撞在迎风侧沉积。相同速度下，随颗粒粒径增加沉积率先增大后减小，在3 m·s-1的烟气流速下颗粒直径为5 μm时飞灰颗粒沉积率最高，为9.49%。保持粒径不变，随速度增大沉积率逐渐降低。

Abstract

A novel structure with rhombus heat transfer surface used in the waste heat boiler was researched. Numerical simulation and experimental investigation were conducted to obtain characteristics of ash distribution and deposition. A deposition model was built to predict the stick

rebound and shedding of an ash particle

and the simulation results were compared with traditional staggered and aligned tubes arrangement. The results indicated that the rhombic surface showed obvious advantages in the heat transfer and ash deposition. The deposits were mainly concentrated on the upper left side. Particle deposited on windward side due to the inertial impaction and on leeward side because of pipe wall vortex. The deposition amount of windward side was higher than that of the leeward side. The deposition increased firstly and then decreased with the increase of the particle size under the same velocity. When the gas velocity was 3 m·s-1 and particle diameter was 5 μm

the ash particle deposition rate was up to 9.49%. For particles of the same size

the deposition rate decreased gradually with increasing velocity.

关键词

Keywords

references

Views

447

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Experimental and large eddy simulation study on gasoline-air mixture explosions in semi-confined pipe with 90° right-angle bend

Characteristics of outdoor air dehumidifier combined with heat pump system and solid desiccant plates

Numerical simulation of gas production from hydrate by depressurization combined with well-wall heating

Numerical simulation and experimental research on novel heat transfer surface

Heat transfer characteristics of honeycomb liquid-cooled power battery module

Related Author

LI Meng

DU Yang

LI Guoqing

WANG Shimao

LIU Chong

WEI Shihao

TU Rang

QU Shilin

Related Institution

Army Logistics University of PLA

Unit 63926

School of Mechanical Engineering, University of Science and Technology Beijing

Guangzhou Research Center for Gas Hydrate, Guangzhou Institute of Energy Conversion, Chinese Academy of Sciences

College of Environmental and Energy Engineering, Beijing University of Technology

⁰