Influences of external moisture content in pulverized coal on discharge characteristics of top discharge blow tank

XU Guiling; LU Ping; XU Pan; LIANG Cai; CHEN Xiaoping

doi:10.11949/j.issn.0438-1157.20160129

您当前的位置：

首页 >

文章列表页 >

Influences of external moisture content in pulverized coal on discharge characteristics of top discharge blow tank

更新时间：2025-11-26

- Influences of external moisture content in pulverized coal on discharge characteristics of top discharge blow tank
- CIESC Journal Issue 7, Pages: 2767-2776(2016)
- 作者机构：
  
  1. 南京师范大学能源与机械工程学院, 江苏省物质循环与污染控制重点实验室,江苏,南京,210042
  2. 东南大学能源与环境学院, 能源热转换及其过程测控教育部重点实验室,江苏,南京,210096
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20160129
  CLC： Q536
- Online First：05 July 2016，
  
  Published：05 July 2016
- 稿件说明：
移动端阅览
XU Guiling, LU Ping, XU Pan, et al. Influences of external moisture content in pulverized coal on discharge characteristics of top discharge blow tank[J]. CIESC Journal, 2016, (7): 2767-2776.
DOI：

XU Guiling, LU Ping, XU Pan, et al. Influences of external moisture content in pulverized coal on discharge characteristics of top discharge blow tank[J]. CIESC Journal, 2016, (7): 2767-2776. DOI： 10.11949/j.issn.0438-1157.20160129.

摘要

在上出料式发送罐密相气力输送实验台上，研究了外水含量对煤粉供料质量流率、固气比以及供料稳定性的影响，获得了内蒙古褐煤的极限供料外水含量和最佳供料外水含量，并结合煤粉流动特性分析，探讨了煤粉极限供料外水含量和最佳供料外水含量的判别方法。结果表明：在初始外水含量为3.3%条件下，在上出料式发送罐壁面以及提升管入口处能够观察到明显的静电放电现象；当外水含量增加至10%时，发送罐内会出现煤粉结拱现象；实验所用内蒙古褐煤的极限供料外水含量在8.7%~10%之间，其最佳供料外水含量大约为4%，在最佳供料外水含量下煤粉供料质量流率和固气比均达到最大值，且供料稳定性最好；当外水含量为供料实验获得的最佳外水含量4%时，煤粉的流动函数达到最大值，同时黏附力达到最小值，煤粉的流动性也达到最佳。在外水含量由8.7%增加至10%的过程中，煤粉流动性由容易流动区域转为有黏性区域，流动性变差。当外水含量为10%时，煤粉处于有黏性区域，流动困难。与供料实验相比，通过剪切实验获得煤粉的流动函数和黏附力，可以作为工业应用中初步判别煤粉极限供料外水含量和最佳供料外水含量的便捷方法。

Abstract

Experimental investigations on the discharge characteristics of pulverized coal with different external moisture content were carried out in a dense-phase pneumatic conveying facility of top discharge blow tank. The effects of external moisture content on solid discharge rate

solid loading ratio and discharge stability were investigated. The limit and the best values of external moisture content for Neimenggu lignite used in the experiments were obtained. Combined with flowability analysis of the pulverized coal

the discriminate methods of limit and the best external moisture content for discharge process were discussed. The results showed that for pulverized coal with original external moisture content of 3.3%

an obvious electrostatic discharge phenomenon could be observed near the wall of the top discharge blow tank and the riser inlet during the discharge process. When the pulverized coal external moisture content was increased to 10%

arching phenomenon would appear in the top discharge blow tank. The limit external moisture content for Neimenggu lignite was in the range of 8.7%—10%

and its best external moisture content was about 4% corresponding to the maximum solid discharge rate and solid loading ratio

and to the best discharge stability. When the external moisture content was 4%

equal to the best external moisture content obtained by discharge experiments

the flow function reached the maximum value

the cohesion reached the minimum value and the pulverized coal flowability became the best. When the external moisture content was increased from 8.7% to 10%

the pulverized coal flowability turned from the easy flow region to cohesive region and the flowability became worse. When the external moisture content was 10%

the pulverized coal was in the cohesive region which meant difficult to flow. Compared with discharge experiments

the flow function and cohesion obtained by the shear tests could be used as preliminary criterion to judging the limit and best values of external moisture content pulverized coal in industrial applications more conveniently.

关键词

Keywords

references

Views

207

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Heat transfer characteristics of oblique droplet impact on liquid film

Wavelet analysis and flow pattern identification in pulsating heat pipes based on temperature signals

Visualization experiment of two-phase flow in parallel flow heat pipe

Simulation study on influence of supplementary gas on dense-phase pneumatic conveying in horizontal pipe under high pressure

Numerical simulation of fully developed liquid-solid flow in vertical narrow channel

Related Author

BAO Minle

GONG Luyuan

GUO Yali

SHEN Shengqiang

YU Qingjie

YANG Honghai

LIU Yuhao

FANG Haizhou

Related Institution

School of Energy and Power Engineering, Dalian University of Technology

School of Environmental Science and Engineering, Donghua University

College of Civil Engineering, Zhengzhou University

School of Mechanical and Power Engineering, Zhengzhou University

Key Laboratory of Energy Thermal Conversion and Control of Ministry of Education, Southeast University

⁰