Influence of feed forward variables on feasible region of model predictive control

ZHANG Jia; LUO Xionglin; XU Feng; XU Jun

doi:10.11949/j.issn.0438-1157.20160036

您当前的位置：

首页 >

文章列表页 >

Influence of feed forward variables on feasible region of model predictive control

更新时间：2025-12-10

- Influence of feed forward variables on feasible region of model predictive control
- CIESC Journal Issue 9, Pages: 3776-3783(2016)
- 作者机构：
  
  中国石油大学自动化系,北京,102249
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20160036
  CLC： P273
- Online First：05 September 2016，
  
  Published：05 September 2016
- 稿件说明：
移动端阅览
ZHANG Jia, LUO Xionglin, XU Feng, et al. Influence of feed forward variables on feasible region of model predictive control[J]. CIESC Journal, 2016, (9): 3776-3783.
DOI：

ZHANG Jia, LUO Xionglin, XU Feng, et al. Influence of feed forward variables on feasible region of model predictive control[J]. CIESC Journal, 2016, (9): 3776-3783. DOI： 10.11949/j.issn.0438-1157.20160036.

摘要

实际生产过程中，预测控制因其解耦性能和强鲁棒性得以广泛使用。在预测控制的研究中大都忽略控制过程中的干扰作用。对于控制过程中存在的可测且变化规律已知的干扰作用，干扰对输出的影响具有一定的可预见性，可通过在预测控制器中引入前馈的方法加以利用。前馈变量的引入会对系统的控制效果产生影响，如果不先对其影响进行分析而直接求解优化，最终结果不能反映预测控制的实际效果。本文从可行域的角度出发，通过几何表现形式，直观分析前馈变量的引入造成的可行域变化；进一步使用了凸空间的思想，通过求解可行域的顶点集合来确定可行域的大小，进而得出前馈变量对系统可行域的影响效果，通过仿真验证了本文方法的有效性。

Abstract

The model predictive control is widely used in real process because of its decoupling and strong robustness. In the past studies

the effects of disturbances on model predictive control were mostly ignored. For the measurable disturbances whose dynamic rules are known

the influence of measurable disturbances on controlled variables can be predicted

and thus the measurable disturbances can be used as feed forward variables in model predictive control. The introduction of feed forward variables will affect the control performance of the system. The result solving directly under no analysis cannot reflect the actual effect of model predictive control. From the viewpoint of feasible region

this paper studies the feasible region changes caused by feed forward variables through the geometric forms. The convex space method is used to determine the size of the feasible region by solving the feasible region of the vertex set and obtain the effects of feed forward variables on the feasible region. The simulations verify the validity of the method in this paper.

关键词

Keywords

references

Views

190

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Corrosion health status assessment method for refining unit pipeline based on GLAE-MLP

A dual-stream multirate GRU soft sensor modeling based on data chunk strategy

ESO-based action dependent heuristic dynamic programming control and its application in a four-stage CSTR process

Research on process control of preparation of mesophase pitch by fluid catalytic cracking slurry oil

Interpretative analysis of carbon deposition process of methanol to olefins catalyst based on NMI-GBR-SHAP

Related Author

HU Jinqiu

MA Mingjun

ZHANG Laibin

DONG Jiayan

ZHANG Zhen

SHI Xudong

WANG Fazheng

XIONG Weili

Related Institution

College of Safety and Ocean Engineering, China University of Petroleum

Key Laboratory of Oil and Gas Safety and Emergency Technology, Ministry of Emergency Management

Key Laboratory of Oil and Gas Production Equipment Quality Inspection and Health Diagnosis, State Administration for Market Regulation

School of Internet of Things Engineering, Jiangnan University

Key Laboratory of Advanced Process Control for Industry (Ministry of Education), Jiangnan University

⁰