Saturated pool boiling from downward facing structured surfaces with grooves

ZHONG Dawen; MENG Ji'an; LI Zhixin

doi:10.11949/j.issn.0438-1157.20160015

您当前的位置：

首页 >

文章列表页 >

Saturated pool boiling from downward facing structured surfaces with grooves

更新时间：2025-12-10

- Saturated pool boiling from downward facing structured surfaces with grooves
- CIESC Journal Issue 9, Pages: 3559-3565(2016)
- 作者机构：
  
  清华大学航天航空学院, 工程热物理研究所,北京,100084
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20160015
  CLC： Q026.4
- Online First：05 September 2016，
  
  Published：05 September 2016
- 稿件说明：
移动端阅览
ZHONG Dawen, MENG Ji'an, LI Zhixin. Saturated pool boiling from downward facing structured surfaces with grooves[J]. CIESC Journal, 2016, (9): 3559-3565.
DOI：

ZHONG Dawen, MENG Ji'an, LI Zhixin. Saturated pool boiling from downward facing structured surfaces with grooves[J]. CIESC Journal, 2016, (9): 3559-3565. DOI： 10.11949/j.issn.0438-1157.20160015.

摘要

核电站熔融物堆内滞留技术是一项关键的严重事故应对策略，该策略已被核电站广泛采用。为增强核电站压力容器下封头外表面的沸腾换热能力，实验研究了常压下朝下沟槽结构表面的池沸腾换热，测量了倾角5°、30°、45°、60°和90°下热通量随壁面过热度的变化，获得了相应倾角下的临界热通量（CHF）。与光表面相比，朝下沟槽结构表面的CHF可提高65%～90%。实验观察发现，在高热通量下朝下沟槽结构表面气泡运动形态存在蒸汽膜和波浪蒸汽层两种结构。分析表明，沸腾换热显著增强、临界热通量大幅提高的原因是沟槽结构大幅增加了换热面积同时还明显改善了表面的润湿性。

Abstract

In-vessel retention is a key severe accident management strategy now widely adopted by some nuclear power plants. The saturated pool boiling heat transfer coefficients and critical heat flux (CHF) were measured from downward facing structured surface with grooves in deionized water to enhance the CHF. The orientations were 5°

30°

45°

60° and 90° (vertical). The results showed that the nucleate boiling heat transfer coefficients and the local CHF for structured surface with grooves were consistently higher than those for plain surface. Compared with plain surface

the CHF increase could reach 65%-90% for structured surface. The vapor blanket and wavy vapor layer bubble structures with different CHF trigger mechanisms on the downward facing surface at high heat fluxes were observed on structured surface. The enhancement of the local CHF and the nucleate boiling heat transfer coefficients was mainly due to the significantly increase of heat transfer area and the grooves that effectively improve surface wettability.

关键词

Keywords

references

Views

169

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Characteristics of gas-liquid two-phase heat transfer in a confined vapor chamber

Experimental study on the downward-facing surface enhanced boiling heat transfer of multiscale groove-fin structures

Research on enhanced boiling heat transfer of multilevel composite wick structure

Experimental research of R1234yf transient spray cooling and influence of cryogen superheat degree

Experimental study of frosting on wavy plate

Related Author

QIN Siyu

LIU Yijia

YANG Jiacheng

TONG Wei

JIN Liwen

MENG Xiangzhao

SHI Haopeng

ZHONG Dawen

Related Institution

School of Human Settlements and Civil Engineering, Xi’an Jiaotong University

Shenzhen Envicool Technology Co. Ltd.

Beijing Key Laboratory of Passive Nuclear Power Safety and Technology, North China Electric Power University

School of Nuclear Science and Engineering, Shanghai Jiao Tong University

School of Energy and Power Engineering, Nanjing University of Science and Technology

⁰