Adsorption of fluorion onto hydrolyzed leather waste impregnated with zirconium (Ⅳ)

ZENG Xue; LUO Xuegang; ZHOU Jian

doi:10.11949/j.issn.0438-1157.20151238

您当前的位置：

首页 >

文章列表页 >

Adsorption of fluorion onto hydrolyzed leather waste impregnated with zirconium (Ⅳ)

更新时间：2025-12-10

- Adsorption of fluorion onto hydrolyzed leather waste impregnated with zirconium (Ⅳ)
- CIESC Journal Issue 4, Pages: 1368-1377(2016)
- 作者机构：
  
  1. 西南科技大学材料科学与工程学院,四川,绵阳,621010
  2. 西南科技大学生物质材料教育部工程研究中心,四川,绵阳,621010
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20151238
  CLC： Q028.3
- Online First：05 April 2016，
  
  Published：05 April 2016
- 稿件说明：
移动端阅览
ZENG Xue, LUO Xuegang, ZHOU Jian. Adsorption of fluorion onto hydrolyzed leather waste impregnated with zirconium (Ⅳ)[J]. CIESC Journal, 2016, (4): 1368-1377.
DOI：

ZENG Xue, LUO Xuegang, ZHOU Jian. Adsorption of fluorion onto hydrolyzed leather waste impregnated with zirconium (Ⅳ)[J]. CIESC Journal, 2016, (4): 1368-1377. DOI： 10.11949/j.issn.0438-1157.20151238.

摘要

将锆(Ⅳ)负载在通过氢氧化钠(NaOH)水解的粒状废弃皮革上制备出新型氟离子(F-)吸附剂。采用扫描电子显微镜(SEM)、X射线能量色散光谱分析(EDX)、X射线光电子能谱分析(XPS)、傅里叶变换红外吸收光谱分析(FTIR)等方法研究了该吸附剂对水溶液中F-的吸附特性及其吸附机理。结果表明:研究条件下

粒状废弃皮革与Zr(NO3)4·5H2O最优的质量比为1:3;该吸附剂对F-的最优吸附pH为4;该吸附剂对F-的吸附等温线符合Langmuir方程

拟合得出对F-的饱和吸附量为30.56 mg·g-1;吸附动力学可用准二级动力学模型描述

属化学吸附

F-以离子交换的形式代替羟基(-OH)与吸附剂中的Zr(Ⅳ)结合形成稳定的化学键

从而达到吸附水溶液中氟离子的目的。

Abstract

A novel adsorbent was prepared from hydrolyzed granular leather waste (ZHGLW) impregnated with Zr(Ⅳ) for fluorion removal. Fluorion adsorption performance and mechanism were investigated by scan electron microscope

energy dispersive analysis of X-ray

X-ray photoelectron spectroscope

and Fourier transform infrared spectroscopy. The results indicate that the optimal mass ratio of hydrolyzed granular leather waste and Zr(NO3)4·5H2O is 1:3 in this study. The maximum removal of fluorion is obtained at pH 3. The isotherm data fit the Langmuir isotherm model well and the obtained maximum fluorion adsorption capacity of the sorbent is 30.56 mg·g-1. The kinetics of fluorion adsorption onto ZHGLW follows the pseudo-second-order model. Fluorion adsorption process is a chemisorption process

which can be described as that -OH is replaced by fluorion in the form of ion exchange and a stable chemical bond forms through fluorion and impregnated Zr(Ⅳ). Thus

ZHGLW could be an efficient adsorbent for fluorion.

关键词

Keywords

references

Views

237

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Ultramicroporous MOF with multiple adsorption sites for CH4/N2 separation

Preparation of acid-rich 13X molecular sieve and its ultra-deep adsorption removal of mercaptan in biodiesel

Immobilize Cu(Ⅰ) into π-complexed MOF adsorbent for selectivity separation of ethane/ethylene

Research progress of hydrogen sulfide deep adsorption materials

Arsenate removal using Donnan dialysis-zerovalent iron combined process

Related Author

GUO Pengtao

WANG Ting

XUE Bo

YING Yunpan

LIU Dahuan

XU Zhichao

YU Zhendong

WU Haofeng

Related Institution

College of Chemical Engineering, Beijing University of Chemical Technology

College of Chemical Engineering, Qinghai University

State Key Laboratory of Heavy Oil Processing, College of Chemical Engineering and Environment, China University of Petroleum

School of Chemistry and Chemical Engineering, Jiangsu University

College of Science, China University of Petroleum

⁰