Numerical simulation of heat transfer process within sub-cooled intermediate fluid vaporizer

SONG Yang; JI Xin; LIN Wensheng

doi:10.11949/j.issn.0438-1157.20151066

您当前的位置：

首页 >

文章列表页 >

Numerical simulation of heat transfer process within sub-cooled intermediate fluid vaporizer

更新时间：2025-12-10

- Numerical simulation of heat transfer process within sub-cooled intermediate fluid vaporizer
- CIESC Journal Issue S2, Pages: 62-65(2015)
- 作者机构：
  
  上海交通大学制冷与低温工程研究所,上海,200240
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20151066
  CLC： K124
- Online First：31 August 2015，
  
  Published：31 August 2015
- 稿件说明：
移动端阅览
SONG Yang, JI Xin, LIN Wensheng. Numerical simulation of heat transfer process within sub-cooled intermediate fluid vaporizer[J]. CIESC Journal, 2015, (S2): 62-65.
DOI：

SONG Yang, JI Xin, LIN Wensheng. Numerical simulation of heat transfer process within sub-cooled intermediate fluid vaporizer[J]. CIESC Journal, 2015, (S2): 62-65. DOI： 10.11949/j.issn.0438-1157.20151066.

摘要

中间流体气化器(IFV)多采用丙烷作为中间流体

利用其蒸发、冷凝相变过程将LNG气化。为了减小气化器体积

采用过冷中间流体换热流程。对过冷丙烷换热流程中的换热器换热过程进行数值模拟

研究影响过冷流体换热的因素。结果表明

随着海水流率的增大

换热增强;随着海水入口温度的升高

丙烷和水的进出口温差变大。在实际的工程应用中

在允许范围内尽量增大海水流率

以提高换热器效率。换热器倾斜角度对换热的影响需通过实验进一步探明。

Abstract

Intermediate fluid vaporizer(IFV)is an essential component for liquefied natural gas(LNG)floating storage and re-gasification unit(FSRU).Two-phase heat transfer process of propane is widely used in IFVs.To decrease the size of IFVs

the sub-cooled intermediate heat transfer process is used in this paper.Taking propane as the intermediate fluid

the heat exchanging process within the heat exchanger was investigated.Numerical simulation of heat transfer process within sub-cooled IFV heat transfer was carried out to find out the factors which may affect the heat transfer process.The results showed that heat transfer was enhanced by increasing the seawater flow rate;temperature difference of propane and seawater between inlet and outlet increased in seawater inlet temperature.Conclusions were drawn that a larger amount of the seawater flow rate was essential to a higher efficiency of the heat exchanger.Further experiments are needed to make clear the effect of inclination angle on heat transfer enhancement.

关键词

Keywords

references

Views

243

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

A multiscale approach for the thermo-mechanical coupling analysis of parallel-flow PCHE core

Simulation research on the boiling heat transfer characteristics of liquid sodium under microgravity

Improvement and numerical validation of quasi-steady-state frosting model based on thermal and mass transfer effect

Characteristics of non-uniform wind velocity distribution in window air conditioner axial fans and their impact on optimizing condenser circuit optimization

Numerical simulation for flow condensation of methanol in horizontal tube

Related Author

WANG Hao

CAI Lujun

BAI Fan

ZHANG Feng

ZENG Yufeng

HE Yurong

WANG Tianyu

WU Linkai

Related Institution

School of Science, Wuhan University of Science and Technology

Hubei Province Key Laboratory of Systems Science in Metallurgical Process

Hubei Key Laboratory for Engineering Structural Analysis and Safety Assessment

School of Mechanical Engineering, Wuhan University of Science and Technology

School of Energy Science and Engineering, Harbin Institute of Technology

⁰