Operation characteristics and optimization of submerged combustion vaporizer

QI Chao; WANG Bojie; YI Chongchong; KUANG Yiwu; WANG Wen; XU Jiawei; HUANG Yu

doi:10.11949/j.issn.0438-1157.20150688

您当前的位置：

首页 >

文章列表页 >

Operation characteristics and optimization of submerged combustion vaporizer

更新时间：2025-12-10

- Operation characteristics and optimization of submerged combustion vaporizer
- CIESC Journal Issue S2, Pages: 198-205(2015)
- 作者机构：
  
  1. 上海交通大学制冷与低温工程研究所,上海,200240
  2. 中海石油气电集团有限责任公司,北京,100027
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20150688
  CLC： K124
- Online First：31 August 2015，
  
  Published：31 August 2015
- 稿件说明：
移动端阅览
QI Chao, WANG Bojie, YI Chongchong, et al. Operation characteristics and optimization of submerged combustion vaporizer[J]. CIESC Journal, 2015, (S2): 198-205.
DOI：

QI Chao, WANG Bojie, YI Chongchong, et al. Operation characteristics and optimization of submerged combustion vaporizer[J]. CIESC Journal, 2015, (S2): 198-205. DOI： 10.11949/j.issn.0438-1157.20150688.

摘要

建立了浸没燃烧式气化器(SCV)传热管的传热计算模型

给出了计算流程

并且通过实际运行参数验证了模型的准确性。基于该模型计算分析了某型SCV额定工况时管内外的温升曲线以及传热系数曲线;讨论了LNG流量、入口参数以及壁面污垢热阻对水浴温度的影响;根据计算结果提出了加装管内扰流装置以强化传热

当管内传热强化系数为3.0时可在原结构基础上使水浴温度降低14.8℃

或在水浴温度保持不变的条件下减少23%的传热面积。

Abstract

A heat transfer model of submerged combustion vaporizer(SCV)heat transfer tube was established and the calculation flow was also presented.The accuracy of this model was verified by the analysis of an engineering example.Based on a certain SCV

the curves of LNG temperature and heat transfer coefficient along the tube were calculated and analyzed in rated condition.The influence of LNG flow rate

LNG inlet temperature

LNG inlet pressure and fouling resistance coefficient on the water bath temperature was discussed.Based on the results above

a tube insert was recommended to enhance the heat transfer.When the heat transfer enhancement coefficient is 3.0

the bath water temperature could be decreased by 14.8℃ if the length of heat transfer tube keeps invariant.Meanwhile

the heat transfer area could be reduced by 23% if the bath water temperature keeps invariant.

关键词

Keywords

references

Views

340

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Multi objective optimization of flow and heat transfer characteristics of modified manifold microchannel heat sink based on machine learning

Study on performance enhancement and cold retention characteristics of solid packed bed cold energy storage

Optimization method of coal-based cooling, heating and power co-generation

Optimization of thermal insulation performance of cryogenic vessel based on actively cooled thermal shield insulation

Analysis and verification of calculation model of heat transfer coefficient of twin screw in the same direction

Related Author

TANG Songzhen

ZHANG Feiyang

YAN Ji

ZHANG Muqiao

GUO Ming

WANG Chenchen

ZHANG Jinya

SUN Na

Related Institution

School of Mechanical and Power Engineering, Zhengzhou University

BK21 FOUR ERICA-ACE Center, Hanyang University

School of Mechanical and Storage and Transportation Engineering, China University of Petroleum

School of Chemical Engineering and Technology, Xi’an Jiaotong University

School of Petrochemical Engineering, Lanzhou University of Technology

⁰