Optimization of flow for modified step feed process treating low COD/TN municipal sewage

WANG Wei; CHEN Qiang; WANG Chuanxin; PENG Yongzhen

doi:10.11949/j.issn.0438-1157.20150081

您当前的位置：

首页 >

文章列表页 >

Optimization of flow for modified step feed process treating low COD/TN municipal sewage

更新时间：2025-11-26

- Optimization of flow for modified step feed process treating low COD/TN municipal sewage
- CIESC Journal Vol. 66, Issue 7, Pages: 2686-2693(2015)
- 作者机构：
  
  1. 黑龙江工程学院土木与建筑工程学院,黑龙江,哈尔滨,150050
  2. 哈尔滨工业大学城市水资源与水环境国家重点实验室,黑龙江,哈尔滨,150090
  3. 广州市市政工程设计研究院,广东,广州,510060
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20150081
  CLC： 703.1
- Online First：05 July 2015，
  
  Published：05 July 2015
- 稿件说明：
移动端阅览
WANG Wei, CHEN Qiang, WANG Chuanxin, et al. Optimization of flow for modified step feed process treating low COD/TN municipal sewage[J]. CIESC Journal, 2015, 66(7): 2686-2693.
DOI：

WANG Wei, CHEN Qiang, WANG Chuanxin, et al. Optimization of flow for modified step feed process treating low COD/TN municipal sewage[J]. CIESC Journal, 2015, 66(7): 2686-2693. DOI： 10.11949/j.issn.0438-1157.20150081.

摘要

采用改良分段进水工艺处理低碳氮比(C/N<3.5)生活污水

研究流量分配对系统处理性能的影响。在其他条件不变的情况下

以实际处理效果以及物料衡算结果为依据来逐步提高首段进水比例以寻求最优的流量运行工况

共确定4组不同的进水流量分配。结果表明:在此碳氮比条件下

通过提高首段进水比例的方法并不能降低厌氧区氮氧化物的含量

甚至出现相反的情况;系统的同步硝化反硝化作用以及微生物同化作用强度对TN的去除起着至关重要的作用;首段进水比例的提高强化了厌氧区聚磷菌的释磷作用

提高了磷酸盐的去除率;综合考虑系统的脱氮除磷效能以及后续可优化空间

确定在进水流量分配比例为6:3:1的工况3为最优工况

系统出水COD、氨氮、总氮、磷酸盐浓度分别为45.98、0.04、17.47和2.43 mg·L-1。

Abstract

By adjusting the distribution ratio of influent flow into anaerobic and anoxic zones

the removal efficiency of pollutants in low C/N(COD/total nitrogen)<3.5 municipal sewage using modified step feed process was analyzed. Keeping the following conditions unchanged: hydraulic retention time (HRT) 10 h

sludge retention time (SRT) 10—15 d

volume of anaerobic zone:volume of total anoxic zones:volume of total aerobic zones 4:9:9

when the actual efficiency obtained and material balance calculation results were utilized to increase gradually the water ratio distributing to the first stage i.e. anaerobic zone

the best operating conditions could be found and 4 kinds of operating conditions determined. The results show that

at given C/N ratio

concentration of nitrogen oxides in anaerobic zone does not decrease with the increase of the water ratio entered into anaerobic zone

even appears the opposite situation. The simultaneous nitrification and denitrification(SND)and microbial assimilation effect intensity play crucial role in TN removal. The rise of water ratio entered into anaerobic zone improves the removal rate of phosphate due to the phosphorus release effect of phosphorus-accumulating bacteria is enhanced in anaerobic zone. Both nitrogen and phosphorus removals as well as subsequent optimization space are considered

one of optimized water distribution ratio is 6:3:1

and at this condition

the effluent concentration of COD

ammonia nitrogen

phosphate is 45.98

0.04

17.47 and 2.43 mg·L-1 respectively.

关键词

Keywords

references

Views

343

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Preparation of C3N4/MIL-125 (Ti) composite and its performance in photocatalytic reduction of Cr (Ⅵ)

Chemical conversion of dissolved organic matter in petrochemical spent caustic along a wet air oxidation pretreatment process

Physical water treatment technology

Isolation, identification and application of highly efficient halotolerant strains for coal chemical reverse osmosis concentrate treatment

Oxygen transfer characteristics and operational performance ofrotating drum biological contactor

Related Author

FAN Hui

HUANG Xuan

ZHANG Zhe

ZHAO Yi

YU Xuelian

YANG Baiyu

KOU Yue

JIANG Juntao

Related Institution

School of Materials Sciences and Technology, China University of Geosciences Beijing

State Key Laboratory of Heavy Oil Processing, College of Chemical Engineering and Environment, China University of Petroleum

School of Resources and Environmental Engineering,State Key Laboratory of Chemical Engineering, East China University of Science and Technology

School of Mechanical and Power Engineering, East China University of Science and Technology

School of Environment and Chemical Engineering, Shanghai University

⁰