Microbial fuel cell anode modified by chemical oxidation

ZHOU Yu; LIU Zhongliang; HOU Junxian; YANG Siqi; LI Yanxia; QIU Wenge

doi:10.11949/j.issn.0438-1157.20141442

您当前的位置：

首页 >

文章列表页 >

Microbial fuel cell anode modified by chemical oxidation

更新时间：2025-12-10

- Microbial fuel cell anode modified by chemical oxidation
- CIESC Journal Issue 3, Pages: 1171-1177(2015)
- 作者机构：
  
  1. 北京工业大学环境与能源工程学院教育部传热强化与过程节能重点实验室,北京,100124
  2. 北京工业大学环境与能源工程学院化学化工系,北京,100124
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20141442
  CLC： K6
- Online First：05 March 2015，
  
  Published：05 March 2015
- 稿件说明：
移动端阅览
ZHOU Yu, LIU Zhongliang, HOU Junxian, et al. Microbial fuel cell anode modified by chemical oxidation[J]. CIESC Journal, 2015, (3): 1171-1177.
DOI：

ZHOU Yu, LIU Zhongliang, HOU Junxian, et al. Microbial fuel cell anode modified by chemical oxidation[J]. CIESC Journal, 2015, (3): 1171-1177. DOI： 10.11949/j.issn.0438-1157.20141442.

摘要

浓HNO3和酸性K2Cr2O7都具有一定的氧化性

分别利用浓HNO3和酸性K2Cr2O7对阳极碳布进行氧化改性处理。通过红外光谱测试显示

碳布表面附着了羟基(—OH)和羧基(—COOH)。通过扫描电镜观察

碳布经过氧化改性后表面明显变粗糙。同时

循环伏安曲线(CV)和交流阻抗曲线(EIS)测试表明

经过改性后的碳布具有良好的电化学特性。分别以经过浓HNO3和酸性K2Cr2O7改性处理后的碳布作为微生物燃料电池(MFC)的阳极

获得的最大功率密度分别为291.11 mW·m-2和438.08 mW·m-2

比未经过改性处理的碳布阳极的功率密度分别提升了21%和82%。

Abstract

Oxidants of nitric acid and acidic potassium dichromate were used to modify anode carbon cloths. Modification was completed by first putting the carbon cloth into nitric acid or acidic potassium dichromate at a given temperature

soaking for 30 min and then rinsing with de-ionized water until no variation in pH and finally putting into a vacuum dryer

drying for 12 h. Fourier transform infrared spectroscopy measurements indicated that many hydroxyls and carboxyls were attached on the carbon cloth surface after modification. SEM results showed that the surface of carbon cloth became rougher than the unmodified one. In addition

cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS) measurements demonstrated that both modified anodes had excellent electrochemical properties. Using the modified carbon cloths as microbial fuel cell (MFC) anodes respectively

such MFCs yielded maximum power densities of 291.11 mW·m-2 and 438.08 mW·m-2

21% and 82% higher than that of the MFC with unmodified carbon cloth anode respectively.

关键词

Keywords

references

Views

492

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Study of urine-powered microbial fuel cell anode modified by graphene-type novel materials

Progress in research of selective oxidation of low carbon polyols over nano-Au catalysts with precise electronic effect regulation

Cold-start characterization of PEMFC based on quasi-two-dimensional modeling

Construction and performance optimization of five-chamber microbial desalination cell for enhanced desalination and bioelectricity generation

Research progress on persulfate-based advanced oxidation technology regulated by chelating agents

Related Author

ZHOU Yu

LIU Zhongliang

HOU Junxian

CHEN Wenwen

LOU Xiaoge

LI Yanxia

ZHAO Mingyue

MENG Fanyu

Related Institution

The Education Ministry Key Laboratory of Enhanced Heat Transfer and Energy Conservation, College of Environmental and Energy Engineering, Beijing University of Technology

State Key Laboratory of Heave Oil Processing, China University of Petroleum (East China)

Norwegian University of Science and Technology, Tronheim

School of Automotive Engineering, Wuhan University of Technology

School of Energy and Power Engineering, Huazhong University of Science and Technology

⁰