Flow and heat transfer characteristics of annular flow in vertical rectangular narrow channel

CHEN Chong; GAO Puzhen; TAN Sichao; YU Zhiting; CHEN Xianbing

doi:10.11949/j.issn.0438-1157.20141094

您当前的位置：

首页 >

文章列表页 >

Flow and heat transfer characteristics of annular flow in vertical rectangular narrow channel

更新时间：2025-12-10

- Flow and heat transfer characteristics of annular flow in vertical rectangular narrow channel
- CIESC Journal Issue 2, Pages: 537-544(2015)
- 作者机构：
  
  哈尔滨工程大学核安全与仿真技术国防重点学科实验室,黑龙江,哈尔滨,150001
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20141094
  CLC： L334
- Online First：05 February 2015，
  
  Published：05 February 2015
- 稿件说明：
移动端阅览
CHEN Chong, GAO Puzhen, TAN Sichao, et al. Flow and heat transfer characteristics of annular flow in vertical rectangular narrow channel[J]. CIESC Journal, 2015, (2): 537-544.
DOI：

CHEN Chong, GAO Puzhen, TAN Sichao, et al. Flow and heat transfer characteristics of annular flow in vertical rectangular narrow channel[J]. CIESC Journal, 2015, (2): 537-544. DOI： 10.11949/j.issn.0438-1157.20141094.

摘要

为了研究竖直窄矩形通道内环状流的流动传热特性

建立了窄矩形通道内环状流的数学物理模型

并进行了实验验证。通过数值求解环状流的数学物理模型得到了环状流区域的压降梯度、沸腾传热系数和液膜内的速度分布。结果表明窄矩形通道内的环状流模型能够很好地预测环状流区域的压降梯度和沸腾传热系数

而且环状流液膜内速度在法向的分布是非线性的

在层流边界层区速度梯度较大。热通量和窄矩形通道的尺寸对液膜的流速有很大影响

随热通量的增加和窄矩形通道尺寸的减小液膜的流速逐渐增加

然而质量流速对液膜流速的影响较小

而且随质量流速的增加液膜的速度逐渐减小。

Abstract

A mathematical model of annular flow in vertical rectangular narrow channel was developed and experimental verification was performed in order to study flow and heat transfer characteristics of annular flow in vertical rectangular narrow channel. Through numerically solving the mathematical model

pressure gradient

boiling heat transfer and liquid film velocity profile in the annular flow region were obtained. The present model could well predict pressure gradient and boiling heat transfer. The liquid film velocity profile of annular flow in the normal direction was not linear

and liquid film velocity gradient was large in the laminar boundary layer. Rectangular narrow channel size and heat flux had significant effect on liquid film velocity profile. Liquid film velocity increased with increasing heat flux and decreased with increasing channel size. The effect of mass flow rate on liquid film velocity was smaller than the effect of heat flux and channel size

and liquid film velocity decreased with increasing mass flow rate.

关键词

Keywords

references

Views

248

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Two-phase frictional pressure drop characteristics of boiling flow in rectangular narrow channel under rolling motion

Study on enhanced pool boiling heat transfer based on self-driven jet device

Experimental study on influence of inner tube movement on charging-discharging performance in horizontal shell-and-tube phase change thermal energy storage exchanger

Experimental study on thermal storage performance of paraffin/TPMS porous AlSi10Mg alloy composite materials

Improvement and numerical validation of quasi-steady-state frosting model based on thermal and mass transfer effect

Related Author

CHEN Chong

GAO Puzhen

YU Zhiting

CHEN Xianbing

SU Zeshi

GAO Ming

ZUO Qirong

DONG Wuhan

Related Institution

Fundamental Science on Nuclear Safety and Simulation Technology Laboratory, Harbin Engineering University

School of Energy and Power Engineering, University of Shanghai for Science and Technology

Shandong Engineering Research Center for High-efficiency Energy Storage and Hydrogen Energy Utilization, School of Nuclear Science, Energy and Power Engineering, Shandong University

Inner Mongolia Guolong Energy Management Co., Ltd.

Shandong Development & Investment Holding Group Co., Ltd.

⁰