Investigations of axial conduction effect on local heat transfer performance in PCHE

ZHANG Haiyan; GUO Jiangfeng; HUAI Xiulan; CUI Xinying

doi:10.11949/0438-1157.20190377

您当前的位置：

首页 >

文章列表页 >

Investigations of axial conduction effect on local heat transfer performance in PCHE

Fluid dynamics and transport phenomena | 更新时间：2026-07-24

- Investigations of axial conduction effect on local heat transfer performance in PCHE
- CIESC Journal Vol. 70, Issue 12, Pages: 4590-4598(2019)
- 作者机构：
  
  1.中国科学院工程热物理研究所，北京 100190
  2.中国科学院大学工程科学学院，北京 100049
- 作者简介：
- 基金信息：
- DOI：10.11949/0438-1157.20190377
  CLC： TK 124
- Received：11 April 2019，
  
  Revised：2019-09-16，
  
  Online First：09 June 2020，
  
  Published：05 December 2019
- 稿件说明：
移动端阅览
张海燕, 郭江峰, 淮秀兰, 崔欣莹. PCHE内轴向导热对局部换热性能的影响研究[J]. 化工学报, 2019, 70(12): 4590-4598

ZHANG Haiyan, GUO Jiangfeng, HUAI Xiulan, CUI Xinying. Investigations of axial conduction effect on local heat transfer performance in PCHE[J]. CIESC Journal, 2019, 70(12): 4590-4598
张海燕, 郭江峰, 淮秀兰, 崔欣莹. PCHE内轴向导热对局部换热性能的影响研究[J]. 化工学报, 2019, 70(12): 4590-4598 DOI： 10.11949/0438-1157.20190377.

ZHANG Haiyan, GUO Jiangfeng, HUAI Xiulan, CUI Xinying. Investigations of axial conduction effect on local heat transfer performance in PCHE[J]. CIESC Journal, 2019, 70(12): 4590-4598 DOI： 10.11949/0438-1157.20190377.

摘要

通过改变印刷电路板式换热器（PCHE）通道壁厚、直径以及冷热侧CO

进口温度差，数值分析了层流条件下，轴向导热对PCHE内超临界压力CO

流动换热的影响。结果表明，考虑轴向导热时，局部热通量沿程变化更加平缓，冷侧对流传热系数在小于拟临界温度区域变小，而热侧对流传热系数在小于拟临界温区域增大；轴向导热仅对热效率峰值附近区域有所影响，其使得峰值略有增大且向低温侧移动；传热熵产主要发生在高温区域，轴向导热可有效降低局部传热熵产。增大壁厚和直径可增大轴向导热的影响，而增大进口温差，轴向导热的影响变化不大。

Abstract

Numerical investigations of the axial conduction effect on the local heat transfer performance of the printed circuit heat exchanger (PCHE)

which has straight channels and use supercritical pressure carbon dioxide (SCO

) as working fl

uid

were conducted under laminar conditions. Variations of local heat flux

heat transfer coefficient

heat effectiveness and entropy generation due to heat transfer in PCHEs were obtained under the conditions with or without axial conduction

when the wall thickness

diameter as well as the inlet temperature difference between the two sides get changed. Then

the effect of the axial heat conduction could be analyzed by comparing the results with/without the axial conduction. It was found that the axial conduction could greatly impact the temperature distributions in both solid and fluid domains and lead to significant changes to the convective heat transfer of SCO

in PCHEs. When the axial conduction exists

the local heat flux variations get more even along the flow direction

and smaller heat transfer coefficient of the cold side as well as larger heat transfer coefficient of the hot side in the region of

T<T

are also observed. The axial conduction would enlarge the peak heat effectiveness slightly and bring it to a lower bulk temperature. The heat transfer entropy production mainly occurs in the high temperature region

and the axial heat conduction can effectively reduce the local heat transfer entropy. Increasing the wall thickness and diameter can increase the influence of axial heat conduction

while increasing the inlet temperature difference

the influence of axial heat conduction does not change much.

关键词

Keywords

references

Ma T , Chu W X , Xu X Y , et al . An experimental study on heat transfer between supercritical carbon dioxide and water near the pseudo-critical temperature in a double pipe heat exchanger [J ] . Int. J. Heat Mass Transfer , 2016 , 93 : 379 - 387 .

Xu R N , Luo F , Jiang P X . Buoyancy effects on turbulent heat transfer of supercritical CO 2 in a vertical mini-tube based on continuous wall temperature measurements [J ] . Int. J. Heat Mass Transfer , 2017 , 110 : 576 - 586 .

Ma Y T , Liu Z Y , Tian H . A review of transcritical carbon dioxide heat pump and refrigeration cycles [J ] . Energy , 2013 , 55 : 156 - 172 .

Turchi C S , Ma Z , Neises T W , et al . Thermodynamic study of advanced supercritical carbon dioxide power cycles for concentrating solar power systems [J ] . J. Sol. Energy. Eng. , 2013 , 135 ( 4 ): 041007 .

Dostál V , Driscoll M , Hejzlar P . A Supercritical Carbon Dioxide Cycle for Next Generation Nuclear Reactors [M ] . MIT , 2004 ,

Haynes B S , Johnston A M T . High-effectiveness micro-exchanger performance [C ] // AIChE 2002 Spring National Meeting . 2002 .

Li Q , Flamant G , Yuan X , et al . Compact heat exchangers: a review and future applications for a new generation of high temperature solar receivers [J ] . Renewable Sustainable Energy Rev. , 2011 , 15 ( 9 ): 4855 - 4875 .

Ishizuka T . Thermal-hydraulic characteristics of a printed circuit heat exchanger in a supercritical CO 2 loop [C ] // Proceedings of the 11th International Topical Meeting on Nuclear Reactor Thermal-Hydraulics . 2005 .

Ngo T L , Kato Y , Nikitin K , et al . New printed circuit heat exchanger with S-shaped fins for hot water supplier [J ] . Exp. Therm. Fluid Sci. , 2006 , 30 ( 8 ): 811 - 819 .

Kim D E , Kim M H , Cha J E , et al . Numerical investigation on thermal-hydraulic performance of new printed circuit heat exchanger model [J ] . Nucl. Eng. Des ., 2008 , 238 ( 12 ): 3269 - 3276 .

Pieve M . A Calculation method for the optimized thermal-fluid dynamic sizing of heat exchangers [J ] . Heat Transfer Eng. , 2008 , 29 ( 6 ): 556 - 564 .

Aneesh A M , Sharma A , Srivastava A , et al . Effects of wavy channel configurations on thermal-hydraulic characteristics of printed circuit heat exchanger (PCHE) [J ] . Int. J. Heat Mass Transfer , 2018 , 118 : 304 - 315 .

Cui X , Guo J , Huai X , et al . Numerical study on novel airfoil fins for printed circuit heat exchanger using supercritical CO 2 [J ] . Int. J. Heat Mass Transfer , 2018 , 121 : 354 - 366 .

褚雯霄 , 李雄辉 , 马挺 , 等 . 不同肋片结构的印刷电路板换热器传热与阻力特性 [J ] . 科学通报 , 2017 , 62 ( 16 ): 1788 - 1794 .

Chu W X , Li X H , Ma T , et al . Heat transfer and pressure drop performance of printed circuit heat exchanger with different fin structures [J ] . Chin. Sci. Bull ., 2017 , 62 ( 16 ): 1788 – 1794 .

Kim T H , Kwon J G , Yoon S H , et al . Numerical analysis of air-foil shaped fin performance in printed circuit heat exchanger in a supercritical carbon dioxide power cycle [J ] . Nucl. Eng. Des ., 2015 , 288 : 110 - 118 .

Meshram A , Jaiswal A K , Khivsara S D , et al . Modeling and analysis of a printed circuit heat exchanger for supercritical CO 2 power cycle applications [J ] . Appl. Therm. Eng. , 2016 , 109 : 861 - 870 .

Baik Y J , Jeon S , Kim B , et al . Heat transfer performance of wavy-channeled PCHEs and the effects of waviness factors [J ] . Int. J. Heat Mass Transfer , 2017 , 114 : 809 - 815 .

Lee S M , Kim K Y . Optimization of zigzag flow channels of a printed circuit heat exchanger for nuclear power plant application [J ] . J. Nucl. Sci. Technol. , 2012 , 49 ( 3 ): 343 - 351 .

Kwon J G , Kim T H , Park H S , et al . Optimization of airfoil-type PCHE for the recuperator of small scale brayton cycle by cost-based objective function [J ] . Nucl. Eng. Des ., 2016 , 298 : 192 - 200 .

Kim S G , Lee Y , Ahn Y , et al . CFD aided approach to design printed circuit heat exchangers for supercritical CO 2 Brayton cycle application [J ] . Ann. Nucl. Energy , 2016 , 92 : 175 - 185 .

Saeed M , Kim M H . Thermal and hydraulic performance of SCO 2 PCHE with different fin configurations [J ] . Appl. Therm. Eng. , 2017 , 127 : 975 - 985 .

Guo J , Huai X . Performance analysis of printed circuit heat exchanger for supercritical carbon dioxide [J ] . J. Heat Transfer-Trans. ASME , 2017 , 139 ( 6 ): 061801 .

Tiselj I , Hetsroni G , Mavko B , et al . Effect of axial conduction on the heat transfer in micro-channels [J ] . Int. J. Heat Mass Transfer , 2004 , 47 ( 12/13 ): 2551 - 2565 .

Lin M , Wang Q W , Guo Z X . Investigation on evaluation criteria of axial wall heat conduction under two classical thermal boundary conditions [J ] . Appl. Energy , 2016 , 162 : 1662 - 1669 .

Maranzana G , Perry I , Maillet D . Mini- and micro-channels: influence of axial conduction in the walls [J ] . Int. J. Heat Mass Transfer , 2004 , 47 ( 17/18 ): 3993 - 4004 .

Hetsroni G , Mosyak A , Pogrebnyak E , et al . Heat transfer in micro-channels: comparison of experiments with theory and numerical results [J ] . Int. J. Heat Mass Transfer , 2005 , 48 ( 25/26 ): 5580 - 5601 .

康蕊 , 厉彦忠 , 杨宇杰 , 等 . 轴向导热对板翅式换热器传热性能的影响 [J ] . 西安交通大学学报 , 2017 , 51 ( 2 ): 140 - 148 .

Kang R , Li Y Z , Yang Y J , et al . Perfromance evaliuation of plate-fin heat exchanger considering effect fo axial heat conduction [J ] . Journal of Xi'an Jiaotong University , 2017 , 51 ( 2 ): 140 - 148 .

Zhai L , Xu G , Quan Y , et al . Numerical analysis of the axial heat conduction with variable fluid properties in a forced laminar flow tube [J ] . Int. J. Heat Mass Transfer , 2017 , 114 : 238 - 251 .

Sadhu S , Ramgopal M , Bhattacharyya S . Steady-state analysis of a high-temperature natural circulation loop based on water-cooled supercritical CO 2 [J ] . J. Heat Transfer-Trans. ASME , 2018 , 140 ( 6 ): 062502 .

Bejan A . Entropy Generation through Heat and Fluid Flow [M ] . Wiley , 1982 .

Ma T , Li L , Xu X Y , et al . Study on local thermal-hydraulic performance and optimization of zigzag-type printed circuit heat exchanger at high temperature [J ] . Energy Convers. Manage ., 2015 , 104 : 55 - 66 .

Guo J , Xu M , Cheng L . Second law analysis of curved rectangular channels [J ] . Int. J. Therm. Sci. , 2011 , 50 ( 5 ): 760 - 768 .

Hesselgreaves J E . Rationalisation of second law analysis of heat exchangers [J ] . Int. J. Heat Mass Transfer , 2000 , 43 : 4189 - 4204 .

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

A multiscale approach for the thermo-mechanical coupling analysis of parallel-flow PCHE core

Numerical study on flow and heat transfer characteristics of airfoil printed circuit heat exchangers

Performance analysis of printed circuit heat exchanger for supercritical carbon dioxide

Simulation of supercritical methane flow and heat transfer characteristics in printed circuit heat exchanger

Comparative analysis of laminar flow and heat transfer characteristics in a circular tube with different shape vortex generators

Related Author

WANG Hao

CAI Lujun

BAI Fan

ZHANG Feng

REN Guanyu

ZHANG Yifei

LI Xinze

DU Wenjing

Related Institution

School of Science, Wuhan University of Science and Technology

Hubei Province Key Laboratory of Systems Science in Metallurgical Process

Hubei Key Laboratory for Engineering Structural Analysis and Safety Assessment

School of Mechanical Engineering, Wuhan University of Science and Technology

School of Energy and Power Engineering, Shandong University

⁰