Numerical simulation of temperature field of roadbed of full size accelerated loading system

宋文宇

您当前的位置：

首页 >

文章列表页 >

Numerical simulation of temperature field of roadbed of full size accelerated loading system

更新时间：2025-12-10

- Numerical simulation of temperature field of roadbed of full size accelerated loading system
- CIESC Journal Issue S2, (2010)
- 作者机构：
  
  哈尔滨工业大学能源科学与工程学院,黑龙江,哈尔滨,150090
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Online First：30 December 2010，
  
  Published：30 December 2010
- 稿件说明：
移动端阅览
宋文宇. Numerical simulation of temperature field of roadbed of full size accelerated loading system[J]. CIESC Journal, 2010, (S2).
DOI：

宋文宇. Numerical simulation of temperature field of roadbed of full size accelerated loading system[J]. CIESC Journal, 2010, (S2). DOI：

摘要

由于新型足尺加速加载试验系统的规模较大，对空气温度、路面温度和路基温度的精确控制是环境模拟控制系统的设计难点。本文利用Fluent软件，对新型足尺加速加载试验系统的子系统——多年冻土模拟系统进行了数值模拟计算。结果表明，制冷管排上方形成平板导热时，在制冷管层厚度为30 cm的情况下，允许管间距的最大值为40 cm，形成平板导热时的平板与制冷管的距离与路基材料无关。路面冷风温度、风速，载冷剂温度，流速，制冷管径确定时，最优管间距为25 cm，且与路基材料无关。当路面冷风温度、风速，载冷剂温度，流速确定，路基内温度达标时，总制冷量与制冷管间距基本无关，而与路基材料有关。

Abstract

Because of the large size of the new type accelerated loading system

the accurate simulation of air temperature

road temperature and roadbed temperature are the key points and also difficult points for designing the system.By using the software Fluent

this paper simulated the running conditions of the everfrost simulation system and obtained the following results.When the thermally conductive surface had become a flat surface

under the condition of the thickness of the pipe layer was 30 cm

the largest pipe pitch was 40 cm

the position of the thermally conductive surface was independent of the roadbed materials.When the conditions of temperature and speed of cold wind

the temperature and the speed of secondary refrigerant and the diameter of the pipes were all fixed values

the optimal tube pitch was 25 cm

which was independent of the roadbed materials.When the conditions of temperature and speed of cold wind

the temperature and the speed of secondary refrigerant and the diameter of the pipes were all fixed values

when the temperature inside the roadbed had reached the requirement

the total energy cost was independent of the pipe pitches but was relevant to the roadbed materials.

关键词

Keywords

references

Views

683

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Experimental study of heat transfer enhancement by pressure waves in cross flow tube bundles

The impact of novel flow channel structure with sudden-expansion ratio on seawater-activated battery

Multi objective optimization of flow and heat transfer characteristics of modified manifold microchannel heat sink based on machine learning

Methods of adaptive prediction and abnormal states traceability for sulphur content in flue gas desulfurization process

Prediction model for COD in petrochemical wastewater influent based on temporal-spatial dual-stream convolutional neural network

Related Author

No data

Related Institution

No data

⁰