Chemical looping combustion of sawdust in a 10 kW<sub>th</sub> interconnected fluidized bed

WU Jiahua; SHEN Laihong; XIAO Jun; WANG Lei; HAO Jiangang

您当前的位置：

首页 >

文章列表页 >

Chemical looping combustion of sawdust in a 10 kW_th interconnected fluidized bed

更新时间：2025-12-10

- Chemical looping combustion of sawdust in a 10 kW_th interconnected fluidized bed
- CIESC Journal Issue 8, Pages: 2080-2088(2009)
- 作者机构：
  
  东南大学热能工程研究所,江苏,南京,210096
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Online First：05 August 2009，
  
  Published：05 August 2009
- 稿件说明：
移动端阅览
WU Jiahua, SHEN Laihong, XIAO Jun, et al. Chemical looping combustion of sawdust in a 10 kW_th interconnected fluidized bed[J]. CIESC Journal, 2009, (8): 2080-2088.
DOI：

WU Jiahua, SHEN Laihong, XIAO Jun, et al. Chemical looping combustion of sawdust in a 10 kW_th interconnected fluidized bed[J]. CIESC Journal, 2009, (8): 2080-2088. DOI：

摘要

设计并建立了10 kWth级串行流化床化学链燃烧反应器系统，以NiO/Al2O3为载氧体，在该系统上进行生物质（松木木屑）化学链燃烧分离CO2的试验研究，探讨了燃料反应器温度T、水蒸气/生物质比率S/B对两个反应器（空气反应器和燃料反应器）气体产物组成以及燃烧效率的影响。试验结果表明，燃料反应器温度是影响生物质化学链燃烧过程的重要因素，随着温度的升高，燃料反应器气体产物中CO2浓度不断上升，CH4浓度显著降低，CO浓度先升高而后迅速下降;较高的反应器温度有助于燃烧效率的提高。随着S/B的增加，燃料反应器气体产物中CO和CH4浓度均会增大，CO2浓度以及燃烧效率有所降低。在100 h的连续试验过程中，采用共沉淀法制备的NiO/Al2O3载氧体展现出良好的氧化-还原性能和较强的持续循环能力，是生物质化学链燃烧理想的载氧体。

Abstract

A 10 kWth interconnected fluidized bed reactor (air reactor and fuel reactor) for chemical looping combustion was designed and built.The experiments on chemical looping combustion of biomass (sawdust) with NiO/Al2O3 oxygen carrier were performed in this reactor.The effects of fuel reactor temperature and steam/biomass ratio (S/B) on the gas composition of both fuel reactor and air reactor

combustion efficiency

etc.

were discussed.The results indicated that the fuel reactor temperature was an important factor which affected the process of chemical looping combustion.With the increase of fuel reactor temperature

CO2 content increased

and CH4 content decreased evidently.CO content increased remarkably with increasing fuel reactor temperature in the temperature range 720—820℃

and reached its maximum at the temperature 820℃

and then decreased remarkably after the fuel reactor temperature exceeded 820℃.A higher fuel reactor temperature would contribute to increasing combustion efficiency.With the increase of steam/biomass ratio

CO and CH4 content increased

CO2 content and combustion efficiency decreased accordingly. In a total continuous operation time of 100 h

the oxygen carrier which was prepared by using impregnation exhibited extremely good oxidation-reduction reactivity and strong recycling ability.It was an ideal oxygen carrier for chemical looping combustion of biomass.

关键词

Keywords

references

Views

463

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Experiments on chemical looping combustion of coal with hematite as oxygen carrier

Chemical looping combustion of coal based on NiO oxygen carrier

A density functional theory study on the sensing of dissolved gases CO and CO2 in transformer oil using boron-doped nitrogen-based graphene

Preparation of core-shell nanomaterials and their application in thermocatalytic hydrogenation of CO/CO2

Preparation of N2 selective ZIF-8 composite membrane for CO2 capture

Related Author

GU Haiming

ZHANG Siwen

GAO Zhengping

SHEN Laihong

XIAO Jun

CAI Tianzi

ZHANG Haifeng

LIN Haidan

Related Institution

东南大学热能工程研究所，洁净煤发电及燃烧技术教育部重点实验室

School of Chemical Engineering, Northeast Electric Power University

State Grid Jilin Electric Power Research Institute Co., Ltd.

Industrial Catalysis Institute, Zhejiang University of Technology

Guangzhou Institute of Energy Conversion, CAS Key Laboratory of Renewable Energy

⁰

Chemical looping combustion of sawdust in a 10 kWth interconnected fluidized bed

DOI：

摘要

Abstract

关键词

Keywords

references

Chemical looping combustion of sawdust in a 10 kW_th interconnected fluidized bed