Simultaneous removal of SO2 and NO by using calcium absorbent with KMnO4 as additive
|更新时间:2025-12-10
|
Simultaneous removal of SO2 and NO by using calcium absorbent with KMnO4 as additive
CIESC JournalIssue 7, Pages: 1810-1815(2007)
作者机构:
清华大学热能工程系,热科学与动力工程教育部重点实验室
作者简介:
基金信息:
DOI:
CLC:
Online First:05 July 2007,
Published:05 July 2007
稿件说明:
移动端阅览
ZHANG Hu, TONG Huiling, WANG Jinyuan, et al. Simultaneous removal of SO2 and NO by using calcium absorbent with KMnO4 as additive[J]. CIESC Journal, 2007, (7): 1810-1815.
DOI:
ZHANG Hu, TONG Huiling, WANG Jinyuan, et al. Simultaneous removal of SO2 and NO by using calcium absorbent with KMnO4 as additive[J]. CIESC Journal, 2007, (7): 1810-1815.DOI:
Simultaneous removal of SO2 and NO by using calcium absorbent with KMnO4 as additive
The simultaneous SO2/NO removal by calcium based absorbent with KMnO4 as additive was studied in a fixed-bed reactor at a low temperature.The experimental results showed that KMnO4 could promote NO removal by calcium hydroxide
and the efficiency of SO2 and NO removal could reach 31.4% and 13.5% respectively while the stoichiometric ratio of Ca/(S+0.5N) was 1.8.A higher temperature improved SO2 capture
but had little influence on NO removal.The presence of water vapor and oxygen in the gas is necessary for NO removal by the absorbent
and SO2 removal efficiency increased with increasing relative humidity which had an optimal value for NO removal.The results of XRD and IC analysis on the products showed the NO removal mechanism
that NO was firstly oxidized into NO2
and then removed by reacting with calcium hydroxide or calcium sulfite into nitrate and nitrite.