Pressure and evaporation rate in a closed LNG tank

LI Yuxing; WANG Wuchang; QIAO Guofa; FENG Shuchu

您当前的位置：

首页 >

文章列表页 >

Pressure and evaporation rate in a closed LNG tank

更新时间：2025-12-10

- Pressure and evaporation rate in a closed LNG tank
- CIESC Journal Issue 5, Pages: 1241-1246(2010)
- 作者机构：
  
  中国石油大学（华东）储建学院
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Online First：05 May 2010，
  
  Published：05 May 2010
- 稿件说明：
移动端阅览
LI Yuxing, WANG Wuchang, QIAO Guofa, et al. Pressure and evaporation rate in a closed LNG tank[J]. CIESC Journal, 2010, (5): 1241-1246.
DOI：

LI Yuxing, WANG Wuchang, QIAO Guofa, et al. Pressure and evaporation rate in a closed LNG tank[J]. CIESC Journal, 2010, (5): 1241-1246. DOI：

摘要

以LNG(液化天然气)为介质、以密闭LNG生产储罐为对象进行了储罐的压力及日蒸发气体量及蒸发率测试实验，结果证明：密闭LNG储罐内的温度场是非均匀的，即气相部分温度高于气液分界面处温度、气液分界面处液体温度高于液相主体的温度;在实验条件下，当初始充满率为0.475时，3部分的温差最大约为2～3℃。存在临界初始充满率，即当初始充满率小于临界充满率时，某一充满率下的日蒸发气体量和蒸发率随时间而增大;当初始充满率大于临界充满率时，某一充满率下的日蒸发气体量和蒸发率先随着时间增加而增大，然后又随着时间的增加而减小。

Abstract

Experiments on the tank pressure

evaporation volume and evaporation rate were carried out in a closed tank with LNG (liquefied natural gas).The results show that there exists a non-uniform temperature field

where the temperature in gas phase is higher than that at gas-liquid interface

and the temperature at gas-liquid interface is higher than that in the bulk phase of liquid.Under the experimental conditions

the maximum temperature difference among the above three parts is about 2—3℃ when the initial filling rate is 0.475.There exits a critical initial filling rate.When the initial filling rate is lower than the critical value

the daily evaporation volume and evaporation rate increase with time; when the initial filling rate is larger than the critical value

they first increase with time and then decrease.

关键词

Keywords

references

Views

740

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Zn-doped PdO/ZrO2 with rich oxygen vacancies for the synthesis of diphenyl carbonate from CO2 and phenol

Controlled synthesis of Bi2MoO6/MoO3 composite fibers via in-situ hydrothermal method and their high-efficiency photocatalytic hydrogen production performance

Physics-informed spatio-temporal graph convolutional network for fermentation processes

Corrosion health status assessment method for refining unit pipeline based on GLAE-MLP

Progress of solar photo-thermo-catalysis for ammonia synthesis and decomposition under mild conditions

Related Author

No data

Related Institution

No data

⁰