Experimental investigation into explosion of premixed gases in linked vessels
|更新时间:2025-12-10
|
Experimental investigation into explosion of premixed gases in linked vessels
CIESC JournalIssue 1, Pages: 260-264(2009)
作者机构:
南京工业大学城市建设与安全工程学院
作者简介:
基金信息:
DOI:
CLC:
Online First:05 January 2009,
Published:05 January 2009
稿件说明:
移动端阅览
YAN Jianjun, JIANG Juncheng, WANG Zhirong. Experimental investigation into explosion of premixed gases in linked vessels[J]. CIESC Journal, 2009, (1): 260-264.
DOI:
YAN Jianjun, JIANG Juncheng, WANG Zhirong. Experimental investigation into explosion of premixed gases in linked vessels[J]. CIESC Journal, 2009, (1): 260-264.DOI:
Experimental investigation into explosion of premixed gases in linked vessels
It is of scientific and practical importance,to do experimental research on the process of premixed gas explosion in linked vessels.In this paper,different firing positions,initial pressures and initial densities were investigated to obtain their impacts on gas explosion pressure in linked vessels.The results showed that if fuel was burned in a big vessel,a higher explosion pressure would result in the linked smaller one.The rate of pressure rise was also rapid.The influence of initial density on the linked vessels was basically consistent with that on a single vessel.If the initial pressure increased,explosion pressure in linked vessels increased as well.Furthermore,it increased more quickly in the small vessel than in the large one.Consequently,during the industrial process,the most effective method is the partition of explosion,that is,to install a separation device on the joint between the vessel and the connecting pipe to prevent explosion from spreading through pipes.
Gas explosion venting of premixed gases in linked vessels
Impact of operating and physical parameters on ultrasonic demulsification of waste oil
Copper removal by induced crystallization from copper-containing wastewater
Heat and mass transfer coefficients based on decoupling characteristics of heat and mass transfer between liquid desiccant and air (Ⅱ)Experiments and application of new method