Characteristics of pollutants emissions from co-combustion of petrochemical sludge with coal in fluidized bed

ZHU Ge; ZHAO Changsui; CHEN Xiaoping; LIN Liangsheng; ZHOU Wu

您当前的位置：

首页 >

文章列表页 >

Characteristics of pollutants emissions from co-combustion of petrochemical sludge with coal in fluidized bed

更新时间：2025-12-10

- Characteristics of pollutants emissions from co-combustion of petrochemical sludge with coal in fluidized bed
- CIESC Journal Issue 10, Pages: 2627-2633(2008)
- 作者机构：
  
  东南大学洁净煤发电及燃烧技术教育部重点实验室
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Online First：05 October 2008，
  
  Published：05 October 2008
- 稿件说明：
移动端阅览
ZHU Ge, ZHAO Changsui, CHEN Xiaoping, et al. Characteristics of pollutants emissions from co-combustion of petrochemical sludge with coal in fluidized bed[J]. CIESC Journal, 2008, (10): 2627-2633.
DOI：

ZHU Ge, ZHAO Changsui, CHEN Xiaoping, et al. Characteristics of pollutants emissions from co-combustion of petrochemical sludge with coal in fluidized bed[J]. CIESC Journal, 2008, (10): 2627-2633. DOI：

摘要

在一座热态循环流化床燃烧试验装置上对石化污泥与煤进行混烧试验，通过对焚烧过程中烟气成分进行分析，着重考察了质量掺混比、二次风率、过剩空气系数和床温对SO2、NOx和多环芳烃排放浓度的影响。试验结果表明，随着质量掺混比的增大，SO2和NOx的排放浓度下降，而多环芳烃排放浓度呈上升趋势。随着二次风率的增加，SO2的排放浓度上升，而NOx的排放浓度呈下降趋势。随着过剩空气系数的增加，SO2的排放浓度下降，NOx的排放浓度呈上升态势。随着床温或者过剩空气系数的增加，烟气中多环芳烃排放浓度均呈先下降后上升趋势。综合考虑稳定燃烧和降低污染物排放等因素，得出一系列最佳燃烧参数。燃烧温度应该控制在850～860℃，过剩空气系数应该控制在1.35左右，二次风率应该控制在40%左右，质量掺混比应该控制在30%左右。在本次试验范围内，各工况SO2、NOx和多环芳烃的排放浓度均满足国家排放标准。

Abstract

The test of cocombustion of petrochemical sludge and coal was conducted in a circulating fluidized bed (CFB) test facility

focusing on the influences of mass mixing ratio

secondary air fraction

excess air coefficient and bed temperature on SO2

NOx and polycyclic aromatic hydrocarbons (PAHs) emissions characteristicsThe experimental results showed that when mass mixing ratio increased

SO2 and NOx concentrations decreased but PAHs emissions increased markedlySO2 concentration in the flue gas increased but NOx concentration decreased with increasing secondary air fractionAs excess air coefficient increased

SO2 concentration decreased but NOx concentration tended to increasePAHs concentration in the flue gas decreased at first and then increased with the increase in bed temperature or excess air coefficientAfter taking those factors

such as stable combustion and reducing pollutant emissions into account

the following operation parameters are recommended : combustion temperature between 850℃ and 860℃

excess air coefficient of 1.35

secondary air fraction 40% and mass mixing ratio 30%During the test runs

SO2

NOx and PAHs concentrations all met the national standard for pollutant emissions.

关键词

Keywords

references

Views

211

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Characteristics of NOx and SO2 emission from combustion of antibiotic mycelial residue with high water content in fluidized bed reactor

DeNOx performance of SCR catalyst for exhaust gas from coal-fired power plant

Simultaneous desulfurization and denitrification by using combination of UV/H2O2 oxidation with Ca(OH)2 absorption

Affected mechanisms of oxygen-deficient pretreatment on reduction of NO by biochar

Study on simultaneous removal of NO and soot by Fe-doped La0.9Sr0.1Co1-xFexO3 catalyst

Related Author

GE Yaxin

ZHANG Guangyi

CUI Lijie

GAO Shiqiu

GAO Yan

LUAN Tao

PENG Jiwei

LÜ Tao

Related Institution

State Key Laboratory of Multi-phase Complex Systems, Institute of Process Engineering, Chinese Academy of Sciences

School of Chemistry and Chemical Engineering, University of Chinese Academy of Sciences

School of Energy and Power Engineering, Shandong University

School of Energy and Environment, Southeast University

School of Energy and Power Engineering, Jiangsu University

⁰