Bubble formation from large submerged single orifice at high gas velocity

SHEN Xuesong; SHEN Chunyin; LI Guang; DAI Gance

您当前的位置：

首页 >

文章列表页 >

Bubble formation from large submerged single orifice at high gas velocity

更新时间：2025-12-10

- Bubble formation from large submerged single orifice at high gas velocity
- CIESC Journal Issue 9, Pages: 2220-2225(2008)
- 作者机构：
  
  华东理工大学联合化学反应工程研究所
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Online First：05 September 2008，
  
  Published：05 September 2008
- 稿件说明：
移动端阅览
SHEN Xuesong, SHEN Chunyin, LI Guang, et al. Bubble formation from large submerged single orifice at high gas velocity[J]. CIESC Journal, 2008, (9): 2220-2225.
DOI：

SHEN Xuesong, SHEN Chunyin, LI Guang, et al. Bubble formation from large submerged single orifice at high gas velocity[J]. CIESC Journal, 2008, (9): 2220-2225. DOI：

摘要

在内径为190mm的鼓泡塔内，研究了空气-去离子水系统在大孔径高气速条件下的单孔气泡形成。考察了五个不同的孔径，分别为4、8、10、15及21mm，孔口气速范围为0.8~154.8m·s-1。以CCD摄像记录气泡的形状及尺寸，根据气泡长径比的变化，得到气泡初始形态转变时的临界孔口气速：当孔口气速低于20m·s-1时，孔口气泡近似于球形，长径比小于1.1；当孔口气速大于50m·s-1时，气泡呈现椭球形

长径比大于1.5。并对气泡尺寸与孔径及孔口气速进行关联

所得关联式对孔径大于3mm、孔口气速在10~80m·s-1范围内所形成的气泡尺寸预测效果较好。

Abstract

The formation of bubbles generated in a bubble column with 190 mm I.D.from large orifices at high gas velocity was studied for air-deionized water system.The experiments were made with orifice diameters varying from 4 mm to 21 mm and hole gas velocity in the range of 0.8—154.8 m·s-1.The bubble shape and bubble size were recorded by CCD camera，critical hole gas velocity for bubble deformation was derived from the transition of aspect ratio of bubbles.The results showed that bubbles were spherical when hole gas velocity was lower than 20 m·s-1.When hole gas velocity was higher than 50 m·s-1，the shape of bubbles changed to elliptical.A correlation equation was established for bubble size as a function of hole gas velocity and orifice diameter，and the equation predicted the bubble size well for orifice diameter larger than 3 mm and hole gas velocity from 10 m·s-1 to 80 m·s-1 in air-deionized water system.

关键词

Keywords

references

Views

369

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Construction of transition metal-based nitrogen-doped carbon and their desulfurization performance

Advantages and risks of swirling cooling granulation towers

A hybrid modeling and optimization strategy for sequential simulated moving bed

A two-stage dual-channel deep learning model for chemical fault classification

Engineering verification and NO emission control of rare earth Y2O3-based catalytic coatings on a metal fiber surface burner

Related Author

No data

Related Institution

No data

⁰