Thermal performance of small capillary pumped loop using water-Cu nanofluids

LV Lunchun; LIU Zhenhua

您当前的位置：

首页 >

文章列表页 >

Thermal performance of small capillary pumped loop using water-Cu nanofluids

更新时间：2025-12-10

- Thermal performance of small capillary pumped loop using water-Cu nanofluids
- CIESC Journal Issue 11, Pages: 2713-2717(2008)
- 作者机构：
  
  上海交通大学机械与动力工程学院
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Online First：05 November 2008，
  
  Published：05 November 2008
- 稿件说明：
移动端阅览
LV Lunchun, LIU Zhenhua. Thermal performance of small capillary pumped loop using water-Cu nanofluids[J]. CIESC Journal, 2008, (11): 2713-2717.
DOI：

LV Lunchun, LIU Zhenhua. Thermal performance of small capillary pumped loop using water-Cu nanofluids[J]. CIESC Journal, 2008, (11): 2713-2717. DOI：

摘要

在稳定的低压条件下，对以水-Cu纳米流体为工质的小型平板式毛细泵回路（CPL）的换热特性进行了实验研究。实验中纳米颗粒的平均粒径为20 nm，纳米流体质量分数为0.2%～2.0%。工作压力为5.62、9.58、15.74 kPa。研究了纳米颗粒质量分数和运行压力对CPL换热性能、最大热通量和热阻的影响。实验结果表明，水-Cu纳米流体替代纯水能够显著提高CPL的换热性能，蒸发器的传热系数最大可提高40％，最大热通量提高18%。存在着一个对应于最大强化换热能力的最佳质量分数，在实验压力范围内最佳纳米颗粒质量分数为1.0%。水-Cu纳米流体是一种适合在CPL中使用的强化传热工质。运行压力对CPL换热特性也有明显影响，压力越高，CPL换热的强化效果越显著。

Abstract

An experimental study was carried out to investigate the thermal performance of a capillary pumped loop（CPL）using water-Cu nanofluid as the working fluid.The study was focused on the influence of the Cu nanoparticle mass fraction and the operation pressure on the heat transfer coefficients of the evaporator，the maximal heat flux and the total thermal resistance.The experimental results indicated that the thermal performance of the CPL was improved by addition of Cu nanoparticles.There existed an optimum nanoparticle mass fraction about 1.0%.The influence of operation pressure on both the evaporating heat transfer coefficient and the maximal heat flux was remarkable.The heat transfer coefficient and maximal heat flux increased with increasing operation pressure.Compared with water，the evaporating heat transfer coefficient and maximal heat flux for nanofluid could increase by 40% and 18%，respectively when the nanoparticle mass fraction was 1.0% and the operation pressure was 15.74 kPa.

关键词

Keywords

references

Views

168

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

套管式相变储能单元的强化换热

基于BP神经网络方法的热管中冷器热工性能分析

Thermal performance of a new copper wire-bonded flat heat pipe

Numerical study on influence of structural parameters of spiral rotor internal insert on heat transfer

Fluid flow and heat transfer characteristics of alumina organic nanofluid

Related Author

王如竹

张鹏

夏莉

陆国栋

俞小莉

颜卫国

LIN Zhenxuan

MA Qi

Related Institution

上海交通大学制冷与低温研究所

1浙江大学能源工程学系，2杭州银轮科技有限公司

清华大学航天航空学院热科学与动力工程教育部重点实验室

浙江大学动力机械及车辆工程研究所

上海交通大学机械与动力工程学院动力机械与工程教育部重点实验室

⁰