ANTIFOULING COMPOSITE MEMBRANES FOR OIL/WATER SEPARATION PREPARED BY SURFACE-MODIFICATION USING INTERFACIAL POLYMERIZATION
|更新时间:2025-12-10
|
ANTIFOULING COMPOSITE MEMBRANES FOR OIL/WATER SEPARATION PREPARED BY SURFACE-MODIFICATION USING INTERFACIAL POLYMERIZATION
CIESC JournalIssue 4, Pages: 664-667(2004)
作者机构:
四川大学化工学院,四川,成都,610065
作者简介:
基金信息:
DOI:
CLC:
Online First:25 April 2004,
Published:25 April 2004
稿件说明:
移动端阅览
WANG Shu, CHU Liangyin, CHEN Wenmei, et al. ANTIFOULING COMPOSITE MEMBRANES FOR OIL/WATER SEPARATION PREPARED BY SURFACE-MODIFICATION USING INTERFACIAL POLYMERIZATION[J]. CIESC Journal, 2004, (4): 664-667.
DOI:
WANG Shu, CHU Liangyin, CHEN Wenmei, et al. ANTIFOULING COMPOSITE MEMBRANES FOR OIL/WATER SEPARATION PREPARED BY SURFACE-MODIFICATION USING INTERFACIAL POLYMERIZATION[J]. CIESC Journal, 2004, (4): 664-667.DOI:
ANTIFOULING COMPOSITE MEMBRANES FOR OIL/WATER SEPARATION PREPARED BY SURFACE-MODIFICATION USING INTERFACIAL POLYMERIZATION
A fouling-resistant ceramic-supported polymer composite membrane was developed for removal of oil-in-water (O/W) microemulsions. The composite membrane was featured with an asymmetric three-layer structure
i.e.
a porous ceramic membrane substrate
a polyethersulfone (PES) ultrafiltration sub-layer
and a polyamide/polyvinyl alcohol (PVA) composite thin top-layer.The PES polymer was cast onto the tubular porous ceramic membrane with the sol-gel method
and the polyamide/PVA composite thin top-layer was fabricated with the interfacial polymerization method. The prepared composite membrane showed good performance for treating the O/W microemulsions with a mean diameter of 2.4 μm. At the operating pressure of 0.4 MPa
the hydraulic permeability remained steady at about 280 L8226;m-28226;h-1 after a period of operation
the oil concentration in the filtrate was always less than 1.15 mg8226;L-1
and the oil rejection coefficient was higher than 99.1% from the beginning of the operation.