Anti-fouling properties of electroless Ni-W-P deposit on heat transfer surface

doi:10.3969/j.issn.0438-1157.2014.z1.064

CIESC Journal ›› 2014, Vol. 65 ›› Issue (S1): 398-402.DOI: 10.3969/j.issn.0438-1157.2014.z1.064

Previous Articles Next Articles

Anti-fouling properties of electroless Ni-W-P deposit on heat transfer surface

CHENG Yanhai¹, CHEN Hengyang¹, YANG Jinyong¹, HAN Dongtai², ZHU Zhencai¹

1. School of Mechanical and Electrical Engineering, China University of Mining and Technology, Xuzhou 221116, Jiangsu, China;
2. School of Electric Power Engineering, China University of Mining and Technology, Xuzhou 221116, Jiangsu, China

Received:2014-02-10 Revised:2014-02-20 Online:2014-05-30 Published:2014-05-30
Supported by:
supported by the Basic Research Program of China(2013CB228305),the Fundamental Research Funds for the Central Universities (2012QNA26) and the Project Funded by the Priority Academic Program Development of Jiangsu Higher Education Institutions.

换热表面Ni-W-P镀层抗垢特性

程延海¹, 陈衡阳¹, 杨金勇¹, 韩东太², 朱真才¹

1. 中国矿业大学机电工程学院, 江苏徐州 221116;
2. 中国矿业大学电力工程学院, 江苏徐州 221116

通讯作者: 程延海
基金资助:
国家重点基础研究发展计划项目（2013CB228305）；中央高校基本科研业务费专项资金项目（2012QNA26）；江苏高校优势学科建设工程项目。

Abstract

Abstract: In the present work, ternary Ni-W-P deposits with different tungsten content were prepared by varying sodium tungstate concentration in electroless plating. Studies on phase transformation behavior carried out by differential scanning calorimetry (DSC) showed that Ni-W-P deposits exhibited higher thermostability and activation energy with the increase of W composition. Further fouling experiments indicated the surfaces of Ni-W-P deposits with different W content inhibited the adhesion of fouling compared with the mild steel surface. However, there is not necessarily a relationship between the fouling adhesion rate and surface roughness or free energy of the ternary Ni-W-P deposits, but is intimately related to the W content.

Key words: Ni-W-P deposits, mass transfer, thermostability, surface, fouling

摘要： 通过调整Ni-W-P化学镀镀液中钨酸钠浓度，获得了钨元素含量不同的三元Ni-W-P镀层。进一步的实验研究表明，随着三元Ni-W-P镀层中钨元素含量的增加，其热稳定性得到显著改善，同时，镀层晶粒转变的激活能值呈增大趋势。三元Ni-W-P镀层的抗垢性随着镀层中钨元素含量的增加而降低，而与镀层表面自由能以及表面粗糙度没有必然的联系。

关键词: Ni-W-P镀层, 传质, 热稳定性, 表面, 结垢

CLC Number:

TK172

CHENG Yanhai, CHEN Hengyang, YANG Jinyong, HAN Dongtai, ZHU Zhencai. Anti-fouling properties of electroless Ni-W-P deposit on heat transfer surface[J]. CIESC Journal, 2014, 65(S1): 398-402.

程延海, 陈衡阳, 杨金勇, 韩东太, 朱真才. 换热表面Ni-W-P镀层抗垢特性[J]. 化工学报, 2014, 65(S1): 398-402.

References 18

[1]	Srbislav B G, Branislav M J, Marko S J, Nikola J B. Analysis of fouling factor in district heating heat exchangers with parallel helical tube coils[J]. International Journal of Heat and Mass Transfer, 2013, 57(1):9-15
[2]	Al-Janabi A, Malayeri M R, Müller-Steinhagen H. Experimental fouling investigation with electroless Ni-P coatings[J]. International Journal of Thermal Sciences, 2010, 49(6): 1063-1071
[3]	Kazi S N, Duffy G G, Chen X D. Fouling and fouling mitigation on heated metal surfaces[J]. Desalination, 2012, 288(1): 126-134.
[4]	Lee J, Kim T J, Kim M H. Experimental study on the heat and mass of Teflon-coated tubes for the latent heat recovery[J]. Heat Transfer Engineering, 2005, 26(2): 28-37
[5]	Cheng Y H, Zou Y, Cheng L, Liu W. Effect of the microstructure on the properties of Ni-P deposits on heat transfer surface[J].Surface and Coatings Technology, 2009, 203 (12): 1559-1564
[6]	Gudmundur R J, Sylvain L, Olafur P P. Used of extended kalman filtering in detecting fouling in heat exchangers[J]. International Journal of Heat and Mass Transfer, 2007, 50(14):2643-2655
[7]	Quan Z H, Chen Y C, Ma C F, et al. Experimental study on anti-fouling performance in a heat exchanger with low voltage electrolysis treatment[J]. Heat Transfer Engineering, 2009, 30(3):181-188
[8]	Lee S H, Young I C. Velocity effect on electronic-antifouling technology to mitigate mineral fouling in enhanced-tube heat exchanger[J]. International Journal of Heat and Mass Transfer, 2002, 45(20):4163-4174
[9]	Zhang Zhongbin(张仲彬), Xu Zhiming(徐志明), Qiu Zhenbo(邱振波). Experimental investigation on effect of surface and flow characteristics on the induction period of fouling[J]. Journal of Engineering Thermophysics (工程热物理学报), 2009, 30(1): 144-146
[10]	Srbislav B G, Branislav M J, Marko S J, Nikola J B. Analysis of fouling factor in district heating heat exchangers with parallel helical tube coils[J]. International Journal of Heat and Mass Transfer, 2013, 57(1):9-15
[11]	Cheng Yanhai(程延海), Zhang Shiju(张世举), Peng Yuxing(彭玉兴), Zhu Zhencai(朱真才), Cheng Lin(程林). Fouling characteristics on amorphous deposit surface of heat exchangers[J]. Journal of Engineering Thermophysics (工程热物理学报), 2012, 33(5): 828-830
[12]	Abdel Hameed R M, Fekry A M. Electrochemical impedance studies of modified Ni-P and Ni-Cu-P deposits in alkaline medium[J]. Electrochimica Acta, 2010, 55: 5922-5929
[13]	Cheong W C, Gaskell P H, Neville A. Substrate effect on surface adhesion/crystallization of calcium carbon[J]. Journal of Crystal Growth, 2013, 363(1):7-21
[14]	Tien S K, Duh J G. Thermal reliability of electroless Ni-W-P coating during the aging treatment[J]. Thin Solid Films, 2004, 469/470:268-273
[15]	Kissinger H E. Variation of peak temperature with heating rate in different thermal analysis[J]. Journal of Research National Bureau Standards, 1956, 57(4):217-221
[16]	Yang Shanrang(杨善让), Sun Lingfang(孙灵芳), Xu Zhiming(徐志明). Development and prospect of research on heat exchanger fouling[J]. Chemical Industry and Engineering Progress(化工进展),2004, 23(10): 1091-1098
[17]	Zhao Liang(赵亮),Zou Yong(邹勇),Liu Yida(刘义达),Liu Wen(刘文),Cheng Lin(程林).Effect of temperature on formation of crystalline fouling on heat exchanger surface[J].CIESC Journal(化工学报),2009, 60 (8): 1938-1943
[18]	Liu Yida, Zou Yong, Zhao Liang, Liu Wen, Cheng Lin. Investigation of adhesion of CaCO3 crystalline fouling on stainless steel surfaces with different roughness[J].International Communications in Heat and Mass Transfer, 2011, 38(6): 730-733

Anti-fouling properties of electroless Ni-W-P deposit on heat transfer surface

换热表面Ni-W-P镀层抗垢特性

PDF (PC)

Knowledge

Abstract

Cite this article

share this article

References 18

Related Articles 15

Recommended Articles

Metrics

Comments

[1]	Xin WU, Jianying GONG, Long JIN, Yutao WANG, Ruining HUANG. Study on the transportation characteristics of droplets on the aluminium surface under ultrasonic excitation [J]. CIESC Journal, 2023, 74(S1): 104-112.
[2]	Jingwei CHAO, Jiaxing XU, Tingxian LI. Investigation on the heating performance of the tube-free-evaporation based sorption thermal battery [J]. CIESC Journal, 2023, 74(S1): 302-310.
[3]	Yitong LI, Hang GUO, Hao CHEN, Fang YE. Study on operating conditions of proton exchange membrane fuel cells with non-uniform catalyst distributions [J]. CIESC Journal, 2023, 74(9): 3831-3840.
[4]	Yue YANG, Dan ZHANG, Jugan ZHENG, Maoping TU, Qingzhong YANG. Experimental study on flash and mixing evaporation of aqueous NaCl solution [J]. CIESC Journal, 2023, 74(8): 3279-3291.
[5]	Tianhua CHEN, Zhaoxuan LIU, Qun HAN, Chengbin ZHANG, Wenming LI. Research progress and influencing factors of the heat transfer enhancement of spray cooling [J]. CIESC Journal, 2023, 74(8): 3149-3170.
[6]	Enzhe BI, Shuangxi LI, Lianxiang SHA, Dengyu LIU, Kaifang CHEN. Multi-objective optimization analysis of high temperature dynamic pressure split ring seal parameters [J]. CIESC Journal, 2023, 74(6): 2565-2579.
[7]	Yuanyuan ZHANG, Jiangyuan QU, Xinxin SU, Jing YANG, Kai ZHANG. Gas-liquid mass transfer and reaction characteristics of SNCR denitration in CFB coal-fired unit [J]. CIESC Journal, 2023, 74(6): 2404-2415.
[8]	Xinyue WANG, Junjie WANG, Sixian CAO, Cui WANG, Lingkun LI, Hongyu WU, Jing HAN, Hao WU. Effect of glass primary container surface modification on monoclonal antibody aggregates induced by mechanical stress [J]. CIESC Journal, 2023, 74(6): 2580-2588.
[9]	Lei HUANG, Lingxue KONG, Jin BAI, Huaizhu LI, Zhenxing GUO, Zongqing BAI, Ping LI, Wen LI. Effect of oil shale addition on ash fusion behavior of Zhundong high-sodium coal [J]. CIESC Journal, 2023, 74(5): 2123-2135.
[10]	Hao WANG, Siyang TANG, Shan ZHONG, Bin LIANG. An investigation of the enhancing effect of solid particle surface on the CO₂ desorption behavior in chemical sorption process with MEA solution [J]. CIESC Journal, 2023, 74(4): 1539-1548.
[11]	Zhiguang QIAN, Yue FAN, Shixue WANG, Like YUE, Jinshan WANG, Yu ZHU. Effect of purging conditions on the impedance relaxation phenomenon and low temperature start-up of PEMFC [J]. CIESC Journal, 2023, 74(3): 1286-1293.
[12]	Yang HE, Senhu GAO, Qingyun WU, Mingli ZHANG, Tao LONG, Pei NIU, Jinghui GAO, Yingqi MENG. Numerical study on heat and mass transfer characteristics of straight slotted fins under wet conditions [J]. CIESC Journal, 2023, 74(3): 1073-1081.
[13]	Lufan JIA, Yiying WANG, Yuman DONG, Qinyuan LI, Xin XIE, Hao YUAN, Tao MENG. Aqueous two-phase system based adherent droplet microfluidics for enhanced enzymatic reaction [J]. CIESC Journal, 2023, 74(3): 1239-1246.
[14]	Siqi WANG, Tianyu GU, Xianfu CHEN, Tong WANG, Jia LI, Wei KE, Xiaofeng LI, Yiqun FAN. Study on separation characteristics and membrane fouling mechanism of ceramic membrane for clarification of Eucommia ulmoides leaves extract [J]. CIESC Journal, 2023, 74(3): 1113-1125.
[15]	Wanyuan HE, Yiyu CHEN, Chunying ZHU, Taotao FU, Xiqun GAO, Youguang MA. Study on gas-liquid mass transfer characteristics in microchannel with array bulges [J]. CIESC Journal, 2023, 74(2): 690-697.