CIESC Journal ›› 2014, Vol. 65 ›› Issue (11): 4413-4419.DOI: 10.3969/j.issn.0438-1157.2014.11.028

Previous Articles     Next Articles

Experimental study on mercury capture using non-carbon sorbents in 100 MW coal-fired power plant

DU Wen1, YIN Libao2, ZHUO Yuqun1, XU Qisheng2, ZHANG Liang1, CHEN Changhe1   

  1. 1. Key Laboratory of Thermal Science and Power Engineering of Ministry of Education, Thermal Engineering Department, Tsinghua University, Beijing 100084, China;
    2. Electric Power Research Institute of Guangdong Power Grid Corporation, Guangzhou 510080, Guangdong, China
  • Received:2014-04-29 Revised:2014-06-11 Online:2014-11-05 Published:2014-11-05
  • Supported by:

    supported by the National Natural Science Foundation of China (51376109).

100MW燃煤电厂非碳基吸附剂喷射脱汞实验研究

杜雯1, 殷立宝2, 禚玉群1, 徐齐胜2, 张亮1, 陈昌和1   

  1. 1. 清华大学热能工程系, 热科学与动力工程教育部重点实验室, 北京 100084;
    2. 南方电网公司广东电力科学院, 广东 广州 510080
  • 通讯作者: 禚玉群
  • 基金资助:

    国家自然科学基金项目(51376109).

Abstract: The mercury removal from the flue gas discharged from a 100 MW coal-fired power plant in China by non-carbon sorbents CuCl2 impregnated alumina and zeolite were experimentally investigated in this paper. When the sorbent were added into, the mercury speciation in flue gas across ESP was directly sampled and analyzed using EPA 30B standard method. The effect of injection rate was studied. The mercury balances measured on-site were between 77.1%—111.5%, and the results of mercury balance after correction suggested that the rates of mercury removal increased with increase of injecting amounts, and was up to 30.6% for modified alumina and 29.2% for modified zeolite. The Hg0 content in flue gas reduced considerably after sorbent injection, and decreased from 40% to 22% when the sorbent injection rate was 0.22 g·m-3. Non-carbon sorbent injection combined with WFGD system could be an effective technology for controlling mercury emission of coal-fired power plant.

Key words: flue gas, sorbents, adsorption, mercury removal, non-carbon

摘要: 选取一个100 MW燃煤电厂对氯化铜改性氧化铝和氯化铜改性沸石进行喷射脱汞实验,应用EPA 30B标准方法对静电除尘器(ESP)前后烟气中的汞价态分布进行了采样和测试.研究了吸附剂喷射量对烟气中汞脱除率的影响.现场测试的汞平衡结果为77.1%~111.5%.经修正的汞平衡结果表明,吸附剂喷射量越大,脱汞率越高.改性氧化铝的脱汞率最高可达30.6%,改性沸石的脱汞率最高可达29.2%.喷射非碳基吸附剂后烟气中元素汞(Hg0)显著下降,在喷射量为0.22 g·m-3时,两种吸附剂可将烟气中Hg0比例由40%降低至22%左右,减少的Hg0主要转化为HgP.非碳基吸附剂与湿法脱硫(WFGD)系统协同使用可以有效减少Hg0向大气中的排放.

关键词: 烟道气, 吸附剂, 吸附, 脱汞, 非碳基

CLC Number: