CIESC Journal ›› 2013, Vol. 64 ›› Issue (7): 2619-2624.DOI: 10.3969/j.issn.0438-1157.2013.07.042

Previous Articles     Next Articles

Iron extraction from pyrite cinder by mixed acid

LIU Pei1, JIANG Jian2, LIU Zongkuan2, ZHANG Lei2, HE Yanling1   

  1. 1. School of Human Settlements and Civil Engineering, Xi'an Jiaotong University, Xi'an 710049, Shaanxi, China;
    2. School of Chemical Engineering and Technology, Xi'an Jiaotong University, Xi'an 710049, Shaanxi, China
  • Received:2012-11-02 Revised:2012-12-25 Online:2013-07-05 Published:2013-07-05
  • Supported by:

    supported by the Pollutant Emission Reduction Technology Integration Demonstration of Industrial Point Source of Weihe in Guanzhong(2011KTZB03-03-01)and the Key Technology Research of Reinjection Treatment for Oilfield Wastewater (2011KTCL03-06).

双酸法提取硫铁矿烧渣中铁

刘培1, 江健2, 刘宗宽2, 张磊2, 贺延龄1   

  1. 1. 西安交通大学人居环境与建筑工程学院, 陕西 西安 710049;
    2. 西安交通大学化学工程与技术学院, 陕西 西安 710049
  • 通讯作者: 贺延龄
  • 作者简介:刘培(1982- ),女,硕士研究生。
  • 基金资助:

    渭河关中段工业点源水污染物减排技术研究集成示范项目(2011KTZB03-03-01); 油田采油废水回注处理的关键技术研究项目(2011KTCL03-06)。

Abstract: Extraction of iron from pyrite cinder by mixed acid of sulfuric acid and hydrochloric acid, and main factors influencing iron leaching rate were investigated.In order to analyze feasibility of extraction of iron from pyrite cinder,the main elements were determined by using X-ray fluorescence spectrum analyzer (XRF).The crystal type of iron oxide in the pyrite cinder was also analyzed by X-ray diffraction (XRD)to understand the presence forms of iron in pyrite cinder.First,10 g dried pyrite cinder were added to a 250 ml three-necked flask.Then,sulfuric acid and hydrochloric acid of specified concentration and quantity were gradually added into the flask under proper stirring,and were kept at a specific temperature for several hours.After filtration,the solution was diluted to 250 ml with distilled water.The diluted solution was used for determination of iron content in leacheate using the stannous chloride-mercury chloride-potassium dichromate method.At last extraction conditions were optimized.The results showed that the significances of each factor on iron extraction were as follows:concentration of sulfuric acid>hydrochloric acid amount>reaction time>sulfuric acid over-dose coefficient.Iron extraction rate increased with higher reaction temperature and increasing amount of hydrochloric acid.However,there existed an optimum combination of sulfuric acid concentration,reaction time and sulfuric acid over-dose coefficient.The optimal conditions were reaction temperature 118—125℃,reaction time 3 h,sulfuric acid concentration 50%—60%,and hydrochloric acid 0.25 ml·(g pyrite cinder)-1,sulfuric acid over-dose coefficient 1.2.Under these conditions,the extraction yield of iron was 93.1%,much higher than that by a single acid.So,the process can improve utilization of iron resource.

Key words: pyrite cinder, extraction rate, double acid leaching, sulfuric acid, orthogonal test

摘要: 应用硫酸-盐酸混酸浸出回收硫铁矿烧渣中的铁,探讨了主要因素对铁浸取率的影响,确定了最佳浸取条件。结果表明,各因素对铁浸取率影响的显著性为:硫酸浓度>盐酸用量>浸取时间>硫酸过量系数;提高反应体系温度,增加盐酸用量均能提高铁的浸取率,而硫酸浓度、反应时间以及硫酸过量系数对铁浸取率存在最佳值。在反应体系沸腾温度为118~125℃,浸取时间为3 h,硫酸浓度为50%~60%,盐酸用量为0.25ml·(g烧渣)-1,硫酸过量系数为1.2的条件下,硫酸烧渣中铁的浸取率达到93.1%,明显高于单一酸的浸取率,提高了铁的资源综合利用率。

关键词: 硫铁矿烧渣, 浸取率, 双酸酸浸, 硫酸, 正交实验

CLC Number: