CIESC Journal ›› 2018, Vol. 69 ›› Issue (8): 3408-3417.doi: 10.11949/j.issn.0438-1157.20180189

Previous Articles     Next Articles

Numerical simulation of fully developed liquid-solid flow in vertical narrow channel

HU Rentao1, REN Libo2, WANG Dewu1, LIU Yan1, ZHANG Shaofeng1   

  1. 1 School of Chemical Engineering and Technology, Hebei University of Technology, Tianjin 300130, China;
    2 Shanghai Heat Transfer Equipment Limited Company, Shanghai 201508, China
  • Received:2018-02-11 Revised:2018-04-10 Online:2018-08-05 Published:2018-04-11
  • Supported by:

    supported by the National Natural Science Foundation of China(21776055) and the Science and Technology Research and Development Program of Hebei Province (12276711D).

Abstract:

Water-glass bead system and Euler-Euler dual-fluid model were used to simulate liquid-solid two-phase flow at fully developed stage of a vertical narrow channel with a dimension of 240 mm in length, 12 mm in width and 1800 mm in height. The results show that the liquid-solid two-phase flow enters full development stage after 0.7 m in vertical direction of the narrow channel. At cross section of the full development stage, particle velocity and concentration in both wide and long axial directions were high in central region but low near wall area. With increase of inlet liquid velocity, solid particle velocity increased at each position of the cross section, while particle concentration decreased at center but increased near wall. With increase of initial solid phase volume fraction, solid particle concentration increased at each position of cross section, while particle velocity decreased slightly at center but increased slightly near wall. Particle thickening effect was observed in the region near three wall junction at both long axial ends of the channel cross-section. In the region of large particle velocity distribution and high concentration gradient along the wide direction of channel cross-section, non-dimensional proportion increased with increase of inlet liquid velocity but decreased with increase of initial solid volume fraction.

Key words: narrow channel, full development section, two-phase flow, flow, CFD

CLC Number: 

  • TQ022.1

[1] 吴晶, 夏梦, 叶莉, 等. 板式换热器强化传热数值研究及热阻分析[J]. 工程热物理学报, 2012, 33(11):1963-1966. WU J, XIA M, YE L, et al. A numerieal study and thermal resistanee analysis of heat transfer enhancement in plate heat exehangers[J]. Journal of Engineering Thermophysics, 2012, 33(11):1963-1966.
[2] CHENG Z, LIN S, HONGFEI O U. Effects of temperature and velocity on fouling by municipal secondary effluent in plate heat exchangers[J]. Journal of Tsinghua University (Science and Technology), 2009, 49(2):240-243.
[3] NAPHON P. Effect of wavy plate geometry configurations on the temperature and flow distributions[J]. International Communications in Heat and Mass Transfer, 2009, 36(9):942-946.
[4] 王茜, 韩怀志, 李炳熙. 板式换热器波纹通道的流动与传热机理[J]. 化工学报, 2017, 68(S1):71-82. WANG X, HAN H Z, LI B X. Flow and heat transfer mechanism of corrugated plate heat exchange[J]. CIESC Journal, 2017, 68(S1):71-82.
[5] 李明春, 肖刚, 史和春, 等. 人字形波纹板相变流动及换热特性研究[J]. 工程热物理学报, 2016, 37(3):581-585. LI M C, XIAO G, SHI H C, et al. Study on phase change flow and heat transfer characteristics of chevron corrugated plate[J]. Journal of Engineering Thermophysics, 2016, 37(3):581-585.
[6] 吴学红, 李灿, 龚毅, 等. 板式换热器相变流动的传热及压降特性[J]. 化工学报, 2017, 68(S1):133-140. WU X H, LI C, GONG Y, et al. Heat transfer and pressure drop characteristic of phase change flow in plate heat exchanger[J]. CIESC Journal, 2017, 68(S1):133-140.
[7] RAO B P, KUMAR P K, DAS S K. Effect of flow distribution to the channels on the thermal performance of a plate heat exchanger[J]. Chemical Engineering and Processing:Process Intensification, 2002, 41(1):49-58.
[8] KANARIS A G, MOUZA A A, PARAS S V. Optimal design of a plate heat exchanger with undulated surfaces[J]. International Journal of Thermal Sciences, 2009, 48(6):1184-1195.
[9] BÉDÉCARRATS J P, STRUB F, PEUVREL C. Thermal and hydrodynamic considerations of ice slurry in heat exchangers[J]. International Journal of Refrigeration, 2009, 32(7):1791-1800.
[10] 齐国鹏, 张金利, 姜峰. 循环流化床换热器中液固二相流的数值模拟[J]. 化学工程, 2011, 39(2):30-34. QI G P, ZHANG J L, JIANG F. Numerical simulation of liquid-solid two-phase flow in circulating fluidized bed exchanger[J]. Chemical Engineering(China), 2011, 39(2):30-34.
[11] QI G, JIANG F. Numerical investigation on prevention of fouling in the horizontal tube heat exchanger:particle distribution and pressure drop[J]. Desalination, 2015, 367:112-125.
[12] 王智, 刘燕, 裴程林, 等. 水平液固循环流化床换热器传热性能研究[J]. 化学工程, 2017, 45(1):55-59. WANG Z, LIU Y, PEI C L, et al. Heat transfer performance of horizontal liquid-solid circulating fluidized bed heat exchanger[J]. Chemical Engineering(China), 2017, 45(1):55-59.
[13] 张鹏, 石新杰. 浆氢在水平圆管内流动的数值模拟[J]. 化工学报, 2014, 65(S2):38-44. ZHANG P, SHI X J. Numerical investigation of slush hydrogen flow in horizontal pipes[J]. CIESC Journal, 2014, 65(S2):38-44.
[14] CHEN X N, WU J D, WANG X D. Numerical simulation of solid-liquid two-phase flow in horizontal circular pipe based on CFD[C]//Control and Decision Conference (CCDC). IEEE, 2016:600-605.
[15] DAYAL P A S, RAJU G S N, MISHRA S. Pattern synthesis using accelerated particle swarm optimization[J]. AMSE Journals, Series:Modelling A, 2016, 89:58-76.
[16] NAYAK B B, CHATTERJEE D. Numerical investigation of convective heat transfer in pipeline flow of multi-sized mono dispersed fly ash-water slurry[J]. International Journal of Heat and Mass Transfer, 2017, 108:1802-1818.
[17] SINGH J P, KUMAR S, MOHAPATRA S K. Modelling of two-phase solid-liquid flow in horizontal pipe using computational fluid dynamics technique[J]. International Journal of Hydrogen Energy, 2017, 42(31):20133-20137.
[18] WANG J H, ZHANG T F, WANG S G. Heterogeneous ice slurry flow and concentration distribution in horizontal pipes[J]. International Journal of Heat and Fluid Flow, 2013, 44:425-434.
[19] REN L B, ZHAO X Q, ZHANG S F. Hydrodynamic investigation of slurry flows in horizontal narrow rectangular channels[J]. International Journal of Heat and technology, 2017, 35(40):730-736
[20] MESSA G V, MALIN M, MALAVASI S. Numerical prediction of fully-suspended slurry flow in horizontal pipes[J]. Powder Technology, 2014, 256:61-70.
[21] MESSA G V, MALAVASI S. Improvements in the numerical prediction of fully-suspended slurry flow in horizontal pipes[J]. Powder Technology, 2015, 270(Part A):358-367.
[22] MESSA G V, MALAVASI S. Computational investigation of liquid-solid slurry flow through an expansion in a rectangular duct[J]. Journal of Hydrology & Hydromechanics, 2014, 62(3):234-240.
[23] GIDASPOW D. Multiphase Flow and Fluidization:Continuum and Kinetic Theory Descriptions[M]. Cambridge:Academic Press, 1994.
[24] SAFFMAN P G T. The lift on a small sphere in a slow shear flow[J]. Journal of Fluid Mechanics, 1994, 22(2):385-400.
[25] GIDASPOW, BEZBURUAH R, DING J. Hydrodynamics of circulating fluidized beds. Kinetic theory approach, fluidization Ⅶ[C]//Proceedings of the Seventh Engineering Foundation Conference on Fluidization. 1992:75-82.
[26] LUN C K K, SAVAGE S B, JEFFREY D J, et al. Kinetic theories for granular flow:inelastic particles in Couette flow and slightly inelastic particles in a general flow field[J]. Journal of Fluid Mechanics, 2006, 140(140):223-256.
[27] DING J, GIDASPOW D. A bubbling fluidization model using kinetic theory of granular flow[J]. AIChE Journal, 1990, 36(4):523-538.
[28] JOHNSON P C, JACKSON R. Frictional-collisional constitutive relations for granular materials, with application to plane shearing[J]. Journal of Fluid Mechanics, 1987, 176:67-93.
[29] NEWITT D M, RICHARDSON J F, GLIDDON, et al. Hydraulic conveying of solids in vertical pipes[J]. Trans. Inst. Chem. Eng., 1961, 39:93-100.
[30] 李玉柱, 贺五洲. 工程流体力学[M]. 北京:清华大学出版社. 2006. LI Y Z, HE W Z. Engineering Fluid Dynamics[M]. Beijing:Tsinghua University Press, 2006.

[1] SHI Suli, LU Yuanwei, YU Qiang, WU Yuting. Optimization of heat removal modes for heat exchanger in molten salt single storage tank [J]. CIESC Journal, 2019, 70(3): 857-864.
[2] WANG Shunhao, ZHU Wenli, HU Zhenggen, ZHOU Rui, YU Liu, WANG Bin, ZHANG Xiaobin. Numerical simulation and experimental validation of evaporation characteristics of scaled liquid hydrogen tank [J]. CIESC Journal, 2019, 70(3): 840-849.
[3] WANG Hanlin, WANG Deqiang, WANG Kai, LUO Guangsheng. Continuous synthesis of anisole in microreactor system [J]. CIESC Journal, 2019, 70(3): 922-928.
[4] YU Jianliang, HOU Yujie, YAN Xingqing, JI Wentao, YU Xiaozhe, WANG Yibo. Experimental study on flame propagation characteristic of polyethylene dust explosion under confined chamber [J]. CIESC Journal, 2019, 70(3): 1227-1235.
[5] WU Xuan, LI Xiaorui, MA Jun, QIN Mengzhu, ZHOU Yahui, LI Haiguang. Behavior characteristics of bubble formation under various nozzle immersion modes [J]. CIESC Journal, 2019, 70(3): 901-912.
[6] ZHOU Xin, DENG Ledong, WANG Hong, ZHU Xun, CHEN Rong, LIAO Qiang, DING Yudong. Effect of cooled cylindrical surface on droplet dynamic behavior [J]. CIESC Journal, 2019, 70(3): 883-891.
[7] NI Chengzhen, DU Wenli, HU Guihua. Impact of turbulence model in coupled simulation of ethylene cracking furnace [J]. CIESC Journal, 2019, 70(2): 450-459.
[8] XUE Yongfei, WANG Yalin, SUN Bei, LI Qianzhong, SUN Jiazhou. Improved state transfer algorithm-based kinetics parameter estimation for cascaded plug flow reactors [J]. CIESC Journal, 2019, 70(2): 607-616.
[9] ZHANG Huahai, WANG Tiefeng. Generality of CFD-PBM coupled model for simulations of gas-liquid bubble column [J]. CIESC Journal, 2019, 70(2): 487-495.
[10] XIA Hongtao, ZOU Siyu, XIAO Jie. Numerical simulation of shear-thinning droplet impacting on randomly rough surfaces [J]. CIESC Journal, 2019, 70(2): 634-645.
[11] LIU Zhongyan, SUN Dahan, JIN Xu, WANG Tianhao, MA Yitai. Evaluation research on boiling heat transfer model of CO2 in tube [J]. CIESC Journal, 2019, 70(1): 56-64.
[12] CHEN Wei, REN Ying. Similarity between fluidization and phase transition [J]. CIESC Journal, 2019, 70(1): 1-9.
[13] XIONG Pan, YAN Shuguang, LIU Weiyin. Structure optimization of cyclone based on response surface method [J]. CIESC Journal, 2019, 70(1): 154-160.
[14] LIU Yingjie, ZHU Jesse. Flow behaviors in bubble-driven liquid-solid fluidized-bed adopting binary particles [J]. CIESC Journal, 2019, 70(1): 91-98.
[15] WANG Haoxian, LI Jianrui, HU Haitao, DING Guoliang, WU Chunlin, CHEN Hui, XING Zhanyang. Analysis of influence of surging on heat transfer characteristics of liquified natural gas flow boiling in channel of plate-fin heat exchanger [J]. CIESC Journal, 2018, 69(S2): 101-108.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!