CIESC Journal ›› 2018, Vol. 69 ›› Issue (7): 3174-3180.DOI: 10.11949/j.issn.0438-1157.20171673

Previous Articles     Next Articles

Simulation of fiber erosion on mold during filling process of fiber reinforced plastic injection molding

JIANG Ben, ZHAI Ming, REN Jianxing, MA Shiheng, SHEN Changyu   

  1. College of Mechanics and Engineering Science, Zhengzhou University, Zhengzhou 450001, Henan, China
  • Received:2017-12-20 Revised:2018-03-20 Online:2018-07-05 Published:2018-07-05
  • Supported by:

    supported by the National Natural Science Foundation of China (U1304107) and College Students Innovation and Entrepreneurship Training Program(2017cxcy091).

纤维增强塑料注射充模过程中纤维对模具的冲蚀磨损模拟

蒋奔, 翟明, 任建行, 马世恒, 申长雨   

  1. 郑州大学力学与工程科学学院, 河南 郑州 450001
  • 通讯作者: 翟明
  • 基金资助:

    国家自然科学基金项目(U1304107);大学生创新创业训练计划项目(2017cxcy091)。

Abstract:

The surface erosion wear of plastic mold caused by the impact of glass fibers was studied. The finite element software ANSYS/LS-DYNA was employed to study the erosion process. A multi-particle erosion finite element model was established and a three-dimensional explicit impact dynamic scheme was carried out to analyze the erosion of the mold under different impacting velocities and incident angles to clarify the erosion mechanism. The results showed that the erosion of glass fibers to the mold was dominated by micro-cutting, and the erosion rate increased with the rising of impacting velocity and tended to rise and decline with the increasing of incident angle.

Key words: fiber reinforced plastics, injection molding, filling process, mold erosion wear, simulation

摘要:

针对塑料模具在玻璃纤维冲蚀下造成的表面磨损问题,运用有限元软件ANSYS/LS-DYNA建立了模具材料多颗粒冲蚀有限元模型,进行三维显式冲击动力学计算,研究纤维在不同冲蚀速度和冲蚀角度下对模具的冲蚀规律,分析冲蚀机理。结果表明,玻璃纤维对模具的冲蚀过程以微切削为主;玻璃纤维对模具的冲蚀磨损率随着冲蚀速度的增加而增加,随着冲蚀角度的增加而呈现先增加后减小的趋势。

关键词: 纤维增强塑料, 注射成型, 充模, 模具冲蚀, 模拟

CLC Number: