表面特性对结霜和融霜排液的影响

doi:10.11949/j.issn.0438-1157.20170622

化工学报 ›› 2017, Vol. 68 ›› Issue (S1): 90-95.DOI: 10.11949/j.issn.0438-1157.20170622

表面特性对结霜和融霜排液的影响

马强, 吴晓敏

清华大学热能工程系, 热科学与动力工程教育部重点实验室, 北京市CO₂资源利用与减排技术重点实验室, 北京 100084

收稿日期:2017-05-15 修回日期:2017-05-25 出版日期:2017-08-31 发布日期:2017-08-31
通讯作者: 吴晓敏,wuxiaomin@tsinghua.edu.cn
基金资助:
国家自然科学基金项目（51476084）；清华大学自主科研计划项目（20131089319）。

Effect of surface wettability on frosting,defrosting and drainage

MA Qiang, WU Xiaomin

Key Laboratory for Thermal Science and Power Engineering of Ministry of Education, Beijing Key Laboratory of CO₂ Utilization and Reduction Technology, Department of Thermal Engineering, Tsinghua University, Beijing 100084, China

Received:2017-05-15 Revised:2017-05-25 Online:2017-08-31 Published:2017-08-31
Supported by:
supported by the National Natural Science Foundation of China (51476084) and the Tsinghua University Initiative Scientific Research Program (20131089319).

摘要/Abstract

摘要：

对亲水表面、裸铝表面和疏水表面上结霜和融霜排液过程进行实验研究，分析了表面特性对冷凝水珠冻结、霜层生长和融霜排液的影响。结果表明：疏水表面上冷凝水珠呈规则球缺状、冻结较晚，而亲水表面和裸铝表面上冷凝水珠形状不规则；相比于亲水表面和裸铝表面上平整霜层，疏水表面上霜层不平整，有凹穴和凸起；疏水表面上霜层平均厚度增长较亲水表面和裸铝表面缓慢；在湿空气温度和冷面温度较低的情况下，表面特性对霜层生长的影响减弱；亲水表面具有较好的排液效果，其循环再结霜量最小。

关键词: 相变, 表面, 传热, 结霜, 霜层形貌, 融霜排液

Abstract:

Frosting processes on hydrophilic surface,bare aluminum surface and hydrophobic surface were experimentally investigated. The condensate water droplets freezing,frost layer growth,defrosting and water drainage on different surfaces were studied. The experimental results show that the condensate water droplet shape is spherical segment on hydrophobic surface while irregular shape on hydrophilic surface and bare aluminum surface. The condensate water droplets freezing process is delayed and the height of frost layer grows slower on hydrophobic surface. Frosting process on different surfaces are tend to be the same,when the humid air temperature and cooling surface temperature are low enough. The frost distribution is even on hydrophilic surface and bare aluminum surface compared with the hydrophobic surface; the hydrophilic surface has less residual meltwater,thus frost mass is lower on hydrophilic surface in frosting/defrosting circulation.

Key words: phase change, surface, heat transfer, frosting, frost morphology, defrosting and drainage

中图分类号:

TK123

马强, 吴晓敏. 表面特性对结霜和融霜排液的影响[J]. 化工学报, 2017, 68(S1): 90-95.

MA Qiang, WU Xiaomin. Effect of surface wettability on frosting,defrosting and drainage[J]. CIESC Journal, 2017, 68(S1): 90-95.

参考文献 21

[1]	KIM K,KIM M H,KIM D R,et al. Thermal performance of microchannel heat exchangers according to the design parameters under the frosting conditions[J]. Int. J. Heat Mass Transfer,2014,71:626-632.
[2]	SONG M J,XIA L,MAO N,et al. An experimental study on even frosting performance of an air source heat pump unit with a multi-circuit outdoor coil[J]. Appl. Energy,2016,164:36-44.
[3]	WU X M,DAI W T,XU W F,et al. Mesoscale investigation of frost formation on a cold surface[J]. Exp. Therm. Fluid Sci.,2007,31:1043-1048.
[4]	SAHIN A Z. Effective thermal conductivity of frost during the crystal growth period[J]. Int. J. Heat Mass Transfer,2000,43:539-553.
[5]	张新华. 外电场对竖直冷表面上自然对流结霜过程影响的研究[D]. 北京:北京工业大学,2006. ZHANG X H. Study of frost formation on a vertical cold plates with and without external electric field under natural convection conditions[D]. Beijing:Beijing University of Technology,2006.
[6]	CHENG C H,WU K H. Observations of early-stage frost formation on a cold plate in atmospheric air flow[J]. J. Heat Transfer,2003,125(1):95.
[7]	LEE K,LEE T,KIM W. A one-dimensional model for frost formation on a cold flat surface[J]. Int. J. Heat Mass Transfer,1997,40(18):4359-4365.
[8]	KANDULA M. Frost growth and densification on a flat surface in laminar flow with variable humidity[J]. Int. Commun. Heat Mass Transfer,2012,39(8):1030-1034.
[9]	HERMES C J L,LOYOLA F R,NASCIMENTO V S. A semi-empirical correlation for the frost density[J]. Int. J. Refrig.,2014,46:100-104.
[10]	KANDULA M. Correlation of water frost porosity in laminar flow over flat surfaces[J]. Special Topics & Reviews in Porous Media,2012,3(1):79-87.
[11]	NASCIMENTO V S,LOYOLA F R,HERMES C J L. A study of frost build-up on parallel plate channels[J]. Exp. Therm. Fluid Sci.,2015,60:328-336.
[12]	WU X M,DAI W T,SHAN X F,et al. Visual and theoretical analyses of the early stage of frost formation on cold surfaces[J]. J. Enhanced Heat Transfer,2007,14(3):257-268.
[13]	LIU Z,GOU Y,WANG J,et al. Frost formation on a super-hydrophobic surface under natural convection conditions[J]. Int. J. Heat Mass Transfer,2008,51(25/26):5975-5982.
[14]	HUANG L,LIU Z,LIU Y, et al. Preparation and anti-frosting performance of super-hydrophobic surface based on copper foil[J]. Int. J. Therm. Sci.,2011,50(4):432-439.
[15]	KIM K,LEE K. Frosting and defrosting characteristics of a fin according to surface contact angle[J]. Int. J. Heat Mass Transfer,2011,54(13/14):2758-2764.
[16]	丁云飞,伍彬,吴会军. 微纳米结构ZnO超亲/疏水表面结霜特性研究[J]. 广州大学学报(自然科学版),2013,12(4):52-55. DING Y F,WU B,WU H J. Study on frost characteristics of micro/nano-structured ZnO super hydrophilic/hydrophobic surface[J]. Journal of Guangzhou University (Natural Science Edition),2013,12(4):52-55.
[17]	JHEE S,LEE K,KIM W. Effect of surface treatments on the frosting/defrosting behavior of a fin-tube heat exchanger[J]. Int. J. Refrig.,2002,25:1047-1053.
[18]	LEE H,SHIN J,HA S,et al. Frost formation on a plate with different surface hydrophilicity[J]. Int. J. Heat Mass Transfer,2004,47(22):4881-4893.
[19]	LIU Z,ZHANG X,WANG H, et al. Influences of surface hydrophilicity on frost formation on a vertical cold plate under natural convection conditions[J]. Exp. Therm. Fluid Sci.,2007,31(7):789-794.
[20]	WANG Z,KWON D,LAWRENCE D K,et al. Frost formation and anti-icing performance of a hydrophobic coating on aluminum[J]. Exp. Therm. Fluid Sci.,2015,60:132-137.
[21]	吴晓敏,褚福强,陈永根.疏水表面的融霜排液特性研究[J].工程热物理学报,2015,36(5):1435-1438. WU X M,CHU F Q,CHEN Y G.Defrosting and drainage characteristics of hydrophobic surfaces[J].Journal of Engineering Thermophysics,2015,36(5):1435-1438.

表面特性对结霜和融霜排液的影响

Effect of surface wettability on frosting,defrosting and drainage

PDF (PC)

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献 21

相关文章 15

编辑推荐

Metrics

本文评价

[1]	吴馨, 龚建英, 靳龙, 王宇涛, 黄睿宁. 超声波激励下铝板表面液滴群输运特性的研究[J]. 化工学报, 2023, 74(S1): 104-112.
[2]	苏伟, 马东旭, 金旭, 刘忠彦, 张小松. 表面润湿性对霜层传递特性影响可视化实验研究[J]. 化工学报, 2023, 74(S1): 122-131.
[3]	张双星, 刘舫辰, 张义飞, 杜文静. R-134a脉动热管相变蓄放热实验研究[J]. 化工学报, 2023, 74(S1): 165-171.
[4]	张义飞, 刘舫辰, 张双星, 杜文静. 超临界二氧化碳用印刷电路板式换热器性能分析[J]. 化工学报, 2023, 74(S1): 183-190.
[5]	陈爱强, 代艳奇, 刘悦, 刘斌, 吴翰铭. 基板温度对HFE7100液滴蒸发过程的影响研究[J]. 化工学报, 2023, 74(S1): 191-197.
[6]	刘明栖, 吴延鹏. 导光管直径和长度对传热影响的模拟分析[J]. 化工学报, 2023, 74(S1): 206-212.
[7]	王志国, 薛孟, 董芋双, 张田震, 秦晓凯, 韩强. 基于裂隙粗糙性表征方法的地热岩体热流耦合数值模拟与分析[J]. 化工学报, 2023, 74(S1): 223-234.
[8]	江河, 袁俊飞, 王林, 邢谷雨. 均流腔结构对微细通道内相变流动特性影响的实验研究[J]. 化工学报, 2023, 74(S1): 235-244.
[9]	吴延鹏, 刘乾隆, 田东民, 陈凤君. 相变材料与热管耦合的电子器件热管理研究进展[J]. 化工学报, 2023, 74(S1): 25-31.
[10]	晁京伟, 许嘉兴, 李廷贤. 基于无管束蒸发换热强化策略的吸附热池的供热性能研究[J]. 化工学报, 2023, 74(S1): 302-310.
[11]	程成, 段钟弟, 孙浩然, 胡海涛, 薛鸿祥. 表面微结构对析晶沉积特性影响的格子Boltzmann模拟[J]. 化工学报, 2023, 74(S1): 74-86.
[12]	李艺彤, 郭航, 陈浩, 叶芳. 催化剂非均匀分布的质子交换膜燃料电池操作条件研究[J]. 化工学报, 2023, 74(9): 3831-3840.
[13]	王玉兵, 李杰, 詹宏波, 朱光亚, 张大林. R134a在菱形离散肋微小通道内的流动沸腾换热实验研究[J]. 化工学报, 2023, 74(9): 3797-3806.
[14]	李科, 文键, 忻碧平. 耦合蒸气冷却屏的真空多层绝热结构对液氢储罐自增压过程的影响机制研究[J]. 化工学报, 2023, 74(9): 3786-3796.
[15]	齐聪, 丁子, 余杰, 汤茂清, 梁林. 基于选择吸收纳米薄膜的太阳能温差发电特性研究[J]. 化工学报, 2023, 74(9): 3921-3930.